Question about 1996 Toyota Corolla
The battery in the key is dead & I do not know what size battery nor do I know how to change it out???
The keyless just pops out . it is easy to take it to a parts store they will help you out and they have all the batteries for them
Posted on Dec 30, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Hi, you need to take the locks to a locksmith to have the keys made, they may have to be diferent than the original ones. good luck.
Posted on Aug 20, 2008
loosen the bolt that is holding the adjuster of the alternator. loosen the belt by pulling it and the alternator would slide in. remove and replace the belt.
do the reverse on installation.
remember to tighten all bolts of the adjuster and alternator after tightening the belt.
tnx 4 using fixya,
Posted on Sep 13, 2008
SOURCE: battery on toyota corolla 2003
make sure battery cables are secure on or into the battery and not loose. If cables are loose it will cause your alternater to fail therfore not fully keeping battery charged. If battery cables are not loose replace battery.
Posted on Nov 17, 2008
Sorry I have been out of town. I went to the library and borrowed the Chilton book. I already had it right, but the back light cover was just not being cooperative. After jiggling it a little more, it came off and I was able to change the bulb. I wish they had made it simpler like the old Camry _ where there wasn't so much difficulty getting at the bulbs.
Thank you for checking.
Posted on Apr 21, 2009
1. Jack up and support car on jack stand. Make sure to chock wheels and or lock the parking brake on.
2. Remove wheel
3. Remove cotter key, castle lock and nut at center of rotor that attaches the axle. - If you lack and impact gun to remove this - it is easier to loosen this nut with all of the wheels on the ground.
4. Remove outer tie rod from spindle, Tap out with hammer. Should not require much force.
5. Remove the single bolt from the lower ball joint and separate from spindle.
6. Pull axle out of spindle and remove from transmission. This may require you to drive this out with a hammer and punch ( I use a brass punch), make sure not to damage threads if you intend to reuse the axle.
To install reverse the procedure. Make sure to replace any cotter key removed with new ones during install.
Torque specs you need are
Ball Joint to Spindle = 91 ftlbs
Tie rod to spindle = 36 ftlbs
Drive axle hub nut = 166 ftlbs
Posted on Jun 07, 2009
Tips for a great answer:
Jan 13, 2015 | 2005 Toyota Corolla
Jul 06, 2014 | 1993 Toyota Corolla
Jun 26, 2013 | Cars & Trucks
Jan 27, 2013 | 1996 Toyota Corolla
Mar 11, 2010 | 2005 Toyota Corolla
Dec 11, 2009 | 1996 Toyota Corolla
Oct 17, 2009 | 1996 Toyota Corolla
Jul 16, 2009 | 1992 Toyota Corolla
Apr 21, 2009 | 1996 Toyota Corolla
123 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: