Question about 2004 Hyundai Santa Fe

Open Question

Remove the centre consul on a 2004 Santa Fe

Centre consul remove

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Fog Light Replacement Hyundai Santa Fe

The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.

Posted on Apr 06, 2009

Ad
goalie39
  • 469 Answers

SOURCE: ''check engine light'' illuminated, 1004 Hyundai, Santa Fe

If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by.

Hope this is of some help.
Ed

Posted on Apr 21, 2009

  • 6 Answers

SOURCE: how to change spark plugs on hyundai 2004 2.4L

Remove the plastic cover that goes over the engine (the one with the Hyundai logo).
At this point, you will see the cables that goe to each fo the spark plugs.
Noting their position, remove them.
The spark plugs are ready to be removed, turn counterclockwise and replace with manufacturer recomended ones.

Posted on May 16, 2009

SOURCE: How to remove rear brake rotors

THE REAR BRAKE ROTOR IS A LOOSE ROTOR AND SHOULD COME OFF EASILY. IF NOT, IT IS POSSIBLE THAT THE ROTOR IS HELD BY RUST ONTO THE HUB OR THE BRAKE SHOES IS STILL EMBEDDED INTO THE ROTOR. REMOVE THE HANDBRAKE CABLE TO ENSURE THAT THE BRAKESHOES COLLAPSE AND TRY TO LOSEN IT AGAIN. IF SEASED ONTO THE HUB BY RUST, KNOCK THE ROTOR WITH A COPPER HAMMER TO BRAKE THE RUST WITH A RUST REMOVER.

Posted on Jul 15, 2009

  • 84 Answers

SOURCE: Change serpentine belt 2004 Hyundai Santa Fe

it uses a spring loaded tensioner.use a breaker bar to rotate the tension and it should just come off.if u need a pic or anything else to do it let me know,

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove centre glove box on 2004 Renault scenic


Lift up gearstick gaitor leaving plastic surrounding in place.

Lift plastic surround and remove lock and Hazzard switch.
Push gaitor through surround and remove surround.
Remove ***** from front of centre consoleand 2 screws from rear.
Follow the side of the centre console down into footwell and remove Popper from each side.
Pull console forward slightly and disconnect cigar lighter.
Remove centre console.
Remove 2 screws below the radio.
Pull radio/air-conditioning surround forward, leave the radio in the surround as it will come out with the surround.
Remove 2 screws holding the glovebox to the centre console.
Open glovebox.
Remove 3 screws along the top front.
Open the fuse box at back of glove box and push the fuse holder up off the flap.
Open passenger door.
Remove dash side panel and remove 2 screws.
Remove kick panel trim in passenger footwell and remove ***** from bottom of glove box. (The glovebox will need to be open to see this *****)
Pull glovebox out slightly. It can be hard to pull out, just be sure you have all screws out.
Disconnect glovebox light and light switch.
Remove glovebox fully.

Apr 03, 2016 | Renault Cars & Trucks

1 Answer

Where is the trans filter located on my 2WD 04 hyundai santa fe?


The 2004 Santa Fe transmission doesn't have a serviceable filter. There's one deep inside the transmission, but the transmission needs to be removed and disassembled to get to it. The only time that filter would be replaced is if the transmission were overhauled. This is the answer I found online, and after trying to change the filter on a 2002 Santa Fe.

Jan 11, 2011 | 2004 Hyundai Santa Fe

2 Answers

What proper size tires are on a 2004 santa fe


find the options sticker in the vehicl.door frame,glove box good starting places.

Nov 21, 2010 | 2004 Hyundai Santa Fe

2 Answers

Rear wheel will not come off after lug nuts are removed, cannot change a flat - how do you get it off?


Sometimes this can happen if the lugnut holes are a little tight or the centre hole jams on the hub. If you jack up the car and loosen the lug nuts but don't remove them, squirt a little Q20 around the holes and the centre hole. Cover a hammer with a cloth and give the rim a couple of hits on the inside so that you are trying to knock it off the car. If it doesn't come loose, spin the wheel 90 degrees and try again, keep going and I am qiute sure you will persuade it off without causing damage.(don't lie under the car whilst you are doing this)

Mar 08, 2010 | 2004 Hyundai Santa Fe

1 Answer

Change the back disc Santa Fe 2004 Hyundai


if it has the to screws like the front remove those.then rotate til the plug is at 6 oclock sn remove the plug;insert a screw driver through the hole and rotate the adjuster to back the parking brake shoes away from the drum surface in the disc.

Sep 25, 2009 | 2004 Hyundai Santa Fe

2 Answers

The blower knob on the a/c in my santa fe doesn't work. Mechanic thinks it's the wiring.


The centre part of the knob has two internal tabs holding it in. A tiny flat screwdriver will pry this part out...watch out...it can pop out and shoot into the backseat!

Jun 09, 2009 | 2001 Hyundai Santa Fe

2 Answers

Changing the tail light assembly on a 2004 hyundai santa fe


Made a video of me changing a brake light but I show how to remove and install the tail light assembly. It's also on a 2005 Hyundai Santa Fe but should be the same.

Apr 11, 2009 | 2004 Hyundai Santa Fe

Not finding what you are looking for?
2004 Hyundai Santa Fe Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...