Question about 2003 Lincoln Town Car
Sounds like a bad window motor or switch, there is no seperate fuse for drivers door
Posted on Dec 29, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Town car rear window problem
u will have to remove door panel and then the window motor to raise manually, then of course with all that apart u might as well replace the defective motor, which I am sure is the problem.
Posted on Feb 18, 2009
SOURCE: R & R power window drivers side
I am in the process of doing this now to my 96 Lincoln Towncar. Today I removed the door panel. Hidden scews that attach the door panel are at end end of the door pull strap. The plastic end pieces are removable and each have a screw underneath securing the top of the door panel.
Hidden behind the water shield material at the top of the door are two nuts that retain the top connection of the window lift. I am going to razor cut a straight line through the water shield material to insert a socket to remove the two nuts and then put duck tape over the razor cuts rather that pull the water shield material from the door frame.
Started drilling on the left rivet to detach window from the regulator and quit for the evening.
Have three rivets to drill to detach the pwoer window motor from the door frame.
Two more rivets at the bottom of the door to drill out to detach the lower window regulator from the door frame.
Do not know how I am going to remove the right rivet of the bracket that hold the window yet. Looks like a would need a long drill bit to reach through the door frame to make contact with the rivet.
The replacement rivets that came with my window regulator are to big for my rivet tool. Could end up using nuts and bolts. Sure would make it easier for the next window regulator replacement.
Hope I have some good luck using the drill tomorrow. kkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkddddddddddddddddddddddddddddddddd
Posted on Mar 08, 2009
Go to this website
Pick owner guide on the left task bar and input your vehicle information and pick get owner guide. Then pick owner guide 1st printing and your fuse info begins on page 134
Posted on May 17, 2009
I have the same problem in my 2001 towncar. I removed the switch control panel (without removing the door panel) by prying up from the front of the panel. There's a spring loaded plug under the mirror adjustment. Once you get that pulled up, the whole unit will lift out. Since there's a two year difference in the models - it MAY not work... however, you might not have to remove the whole door panel as you think.
In my case, the wiring was bad.
Posted on Sep 03, 2009
SECTION 501-05: Interior Trim and Ornamentation
2003 Town Car Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 01/28/2002
Front Door Trim Panel Printable View (206 KB)
Removal and Installation
NOTE: LH side shown, RH side similar.
Open the screw covers.
Posted on Apr 05, 2010
Tips for a great answer:
Mar 25, 2014 | 2003 GMC Sonoma Extended Cab
Apr 18, 2013 | 1998 Lincoln Town Car
Dec 29, 2012 | 2003 Lincoln Town Car
Feb 20, 2010 | 2003 Volkswagen Eurovan
Oct 03, 2009 | 2003 Ford Expedition
Jun 24, 2009 | 2003 Subaru Forester
May 20, 2009 | 2003 Chevrolet Suburban 1500
Apr 13, 2009 | 1999 Ford Windstar
Apr 08, 2009 | 2003 GMC Yukon Denali
137 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: