Question about 2001 Chrysler LHS

Open Question

Where is the flasher relay switch located on the Chrysler LHS

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76846 Answers

SOURCE: chrysler LHS won't start!!

Driver side at rear of engine next to oil pan goes into the bell housing.

Posted on Nov 24, 2008

Ad
  • 2039 Answers

SOURCE: where are the spark plugs located on the 3.5 liter

you have to remove the planium air intake and remove the ignition coil and plug are under it fairly a big job if our not use to it you have to remove lots of part be carefull please rate this a fixya our post was answer good luck pierre

Posted on Mar 08, 2009

mcgyver468
  • 710 Answers

SOURCE: Trying to locate cooling fan relay switch?

Driver's side in the fuse/relay box under the hood.

Posted on Apr 25, 2009

  • 14036 Answers

SOURCE: replaced cracked radiator in 2000 Chrysler LHS but car still overheating. What could be the problem?

fix the radiator first.because coolant temperature sensor need to be in antifreeze.when antifreeze get up to 190 degrees. the coolant sensor act as a thermostat.it resistance decrease then the pcm will command cooling fans to run.if antifreeze low the coolant temperature sensor not going to work. engine is going to over heat.

Posted on May 29, 2009

  • 11 Answers

SOURCE: car

on the driver side of the car, under the engine where the transmission and engine meet. you'll know it by the large, red wire running to it.

Posted on Aug 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to locate turn signal flashers on 1999 LHS?


It Is A Combination Flasher And Is Located--Left Side Of Dash Between Junction Block (fuse panel) And Brake Pedal

Feb 26, 2015 | 1999 Chrysler LHS

1 Answer

Where is relay for starter of 1997 chrysler lhs located?


under the hood fuse box near the battery the location of relay's etc should be on the lid

Jul 10, 2014 | 1997 Chrysler LHS

1 Answer

1997 Chrysler Sebring hazard light relay location


The flasher is mounted to the back side of the multi-function switch. To gain access the upper steering column cover must be removed.

Feb 04, 2014 | 1997 Chrysler Sebring

2 Answers

Chrysler Vision hazard light


on some of these models, the hazard switch operates through its own flasher fuse. if this is the case, locating and replacing the fuse ($4) should do it. Location should be in the owners manual.

Nov 10, 2013 | 1997 Chrysler LHS

1 Answer

Do you know where i am suppose to replace the flasher fuse on a chrysler lhs 1999


The flasher is located under the drivers side dash... Look to the left of the steering column area. If you have purchased a replacement, then just look for a similar looking flasher. Best of Luck!

Aug 20, 2011 | 1999 Chrysler LHS

1 Answer

Which relay controls the right blinker on a 97 LHS, there are several in the engine fuse compartment.


I think there is only one relay for the turn signals, and one relay for the four way flashers. The cover should tell which relay is for what device

Jun 30, 2009 | 1997 Chrysler LHS

1 Answer

Blinker and flasher does not work


you might want to see if there is a flasher relay on you car a auto parts store can tell you they are cheap around 8 to 25 dollars i would start there first if they are not flashing

Jun 25, 2009 | 2000 Chrysler LHS

1 Answer

I have no turn signals or flashers and can not locate the turn signal relay


the two wires that hook on the positive batter terminal brown white are probable your problem.

Mar 22, 2009 | 1997 Chrysler LHS

1 Answer

Can't find turn signal relay.


check the hazard switch on some cars its part of the hazard switch or if the conection is bad they none of it will work.

Mar 16, 2009 | 1994 Chrysler LHS

Not finding what you are looking for?
2001 Chrysler LHS Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...