Question about 2000 Mercury Mountaineer

1 Answer

Horn Wiring 2000 Mercury Mountaineer

My son tried to replace his horn (kept blowing fuses) with an aftermarket horn, and I am going to put back in an OEM replacement. The one he got is a piece of junk
He didn't keep the original horns or wires
The replacement he got is a single note horn, the OEM should be (2) horns, a high note and a low note
Are the 2 horns wired in series....12vdc to one connector on horn #1, jumper cable from horn #1 to horn #2, and connector on horn #2 to ground?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

No/ you have 2 horns your right about that but its one wire connector for each horn usually one horn on the right and the other on the left/ the horns should be slide in connector and if he cut them for one doesnt seem right/ I bet that was the problem he tried using the same wire from the original horns when he kind of grounded the horn so it would not work / but there is only one wire per horn/ Please rate my response/ Thank you very much

Posted on Jan 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alaam sound is turned off in 2000 mercury mountaineer


The actual alarm horn may be disconnected /shorted bad ground or burnt out . Is the alarm horn the same as the car horn? Does the car horn work? Alarm horns popular for burning out.

Sep 26, 2015 | 2000 Mercury Mountaineer

3 Answers

My horn wont blow. It is not a fuse. I have checked all three fuse boxes.


put power from battery direct to horn, if it works clean connector that attaches to horn. very common problem

Mar 06, 2015 | 2006 Pontiac G6

1 Answer

Need a fuse box diagram for a 2004 mercury sable. Horn stopped working


1) Check for power to horn unit with steering wheel horn switch depressed. If power present, replace horn unit.

2) Check horn switch operation. Repair or replace.

3) Check continuity from driver's horn switch mechanism and horn wiring. If faulty, then trace wiring back to fuse box and relay assembly.

Make sure you haven't skipped any steps before attacking the fuse box issue.

Nov 03, 2012 | 2004 Mercury Sable

1 Answer

Replaced horn and now it wont work. Where is the fuse for the horn on a 2000 Merc Mountaineer


The fuse for the horn would be in the power distribution box located under the hood in the engine compartment (see picture below). Also below is a diagram of the fuse layout. The fuse you want to check will be the fuse in the number 10 position and should be a 15 amp fuse. There is a horn relay as well and the is the relay in that same box in the number 7 position. I hope this helps and good luck.


clifford224_408.jpg

clifford224_409.jpg

Aug 30, 2011 | 2000 Mercury Mountaineer

2 Answers

2006 grand prix horn fuse keeps blowing. what should i look for


horn may be shorted internally. Try pulling the connector off the horn, put in a fresh fuse, see if it blows.

If it still blows, you have a short in the wiring or the relay. If there is no obvious short in the wiring, change the relay.

If the fuse doesn't blow with the horn disconnected, replace the horn.

Sep 11, 2010 | 2006 Pontiac Grand Prix

2 Answers

99 dodge durango. My horn keeps blowing the 20 amp fuse under hood. There is also a horn relay. Could that be the problem? The horn will work after I replace the 20 amp, but blows within a few times of...


could be you might check it out. many items take the same relay so you might try exchanging it with another one with the same numbers. If that isn't it you may have a short in the horn itself.

Aug 11, 2010 | 1999 Dodge Durango

1 Answer

Where is the horn located in a 2000 mercury mountaineer V8?


I don't have my manual at the moment, but I think it's under the battery tray.

May 15, 2010 | 2000 Mercury Mountaineer

1 Answer

I need to get a fuse box layout for 1999 Saturn SL2. The horn is not working in my sons car and we would like to determine whether or not it is the fuse. We can't tell which fuse is for the horn because...


The saturn horns ARE notorious for failing, you may have to replace the horn because it has a built in horn relay that is the cause of the failure. YOU WILL KEEP BLOWING FUSES if the horn is not working because it's grounding out through the bad relay that is built into the horn. DON'T go with a loud or aftermarket horn if you don't know how to wire it safely or you will fry the clock spring in the steering wheel, just stick with the stock horn and you will be fine.

Mar 29, 2010 | Saturn SL2 Cars & Trucks

1 Answer

On my 1972 duster,when i blow the horn,the fuse blows and the tail lights go out also. the same fuse runs both.what could be the problem?


This sounds like the horn may have a short in it somewhere. Does the horn blow at all? Try this: Make sure you have a good fuse installed to this circuit again. Disconnect the horn and place a volt/ohm meter set to DC volts on the horn connections. If there is just 1 wire going to the horn, put that wire on the red wire of the meter. Put the black wire of the meter to a good ground, preferably the negative battery terminal. Now press the horn and see if there is a reading of around 12 Volts. If so, replace the horn. If not, and the fuse blows again, check the wiring for a fray/short to ground. When you're looking at the horn of course, make sure the positive lead isn't shorting to ground as well.

I hope this helps! Let me know if you need any more assistance! :)

-Jason

Feb 11, 2010 | 1983 Plymouth Gran Fury

1 Answer

Electical


You may have some short circuits in your wiring, a bad horn relay or horn unit, and/or a bad wiper motor. Hard to tell without actually looking at it.
Try this:
Disconnect the horn, and try another fuse. Does it blow? If not, the horn is shorted, and needs replaced. If it blows, remove the horn relay & try another fuse. Same with the wiper motor, unplug it and try another fuse. If it does not blow, you need a wiper motor.

Sep 26, 2008 | 1985 Toyota 4Runner

Not finding what you are looking for?
2000 Mercury Mountaineer Logo

Related Topics:

507 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...