Hi,
I have a Honda Stream 2.0L 2002 model and the central locking has stopped working. (European MPV, similar to Civic)
The driver's door opens and locks with the key, but not the remote. There is a clicking noise when the remote operates and it sets the alarm/ immobilizer OK. The other 3 doors and the tailgate stay locked and I can't open them. Any ideas?
Thanks,
Alan
SOURCE: I have a 57 honda
get in the vehicle press hold the red button of the transmitter then on and off the ignition,continue till the alarm beep then release the transmitter,your remote control is ready to use.
please rate me.
SOURCE: car will not jump start
Check battery voltage. If volts are very low, put on charger. In many cases, you can't jump through a really dead battery... not enough voltage gets through to computer etc to make systems operate.
Battery may be used up... if it will not take a charge, replace it and check charging system before driving. PS: use a charger to charge battery. If it is very low, you candamage charging system in other vehicle. Also,,, You cleaned terminals already RIGHT???
SOURCE: Central locking not working, Chrysler Voyager Limited 2005
hi this works on most voyagers disconect the possative terminal on the battery for ten minites excactly then reconnect and happy days your voyager centrol locking should work ok good luck
SOURCE: VW Polo 2000 1.4 16V Blowing fuse for Central locking / windows
car electrics are a nightmare. the car lights up when a door is open i presume. and by bypassing the central locking. the electric computer says there is a fault. and will not start. that i think is programed in. best thing to do is. go to phone VW dealer ask about diagnostic test without repair. about £35 then fix it yourself. they garentee it right I think. the dealers have come into line better with that kind of thing phone and ask anyway.
SOURCE: 2004 Honda Accord Euro. Central
I am a mechanic and had the same problem with a 2005 Acord that I purchased couple of months ago. Contact through the trade provided little help. The problem arose during a week that we in Adelaide, South Australia had a record o 40+ degrees centigrade heat. I noticed the drop knob slightly moving when the immobiliser was activated, but the drivers door failed to lock. Key locking would lock all doors however.
The cost of a door actuator from a Honda dealer was $185.00 (Aus), about $250 (US). The spare parts guy told me they had them in stock and sold a number of them. As a result I decided to find out whether the actuator was in fact faulty. I susequently removed the door lock and actuator assembly from the door. (A fiddly type job). The actuator assembly is in a plastic sealed assembly. By using a lot of patience and a box cutter I was able to cut around the assembly and then carefully lever the plastic housing apart. This revealled the small electric motor (similar to a slot car motor) that drove a worm and wheel assembly and a system of cams that actuated the door lock system. I found on dismantling the electric motor that the armature was coated with grease from the wormwheel /cam assembly that is mounted above the motor when installed in the vehicle. I cleaned the armature and brushes using superfine wet and dry carborundum paper, undercut and cleaned out the two armature segments of all remaining grease with a solvent. The motor was then tested with 12 volts and found to be ok. I then reinstalled the motor and glued the housing back together. It now works fine. I believe the housing was either initially overfilled with lubricant or that the high ambient temperature caused the grease to melt and flow into the elecric motor contaminating the motor. (There is no seal between the gearbox and the electric motor). The job took a few hours from start to finish but I saved the cost of purchasing the part and didn't let it beat me.
Cheers and beers
Alistair Buckley
1,424 views
Usually answered in minutes!
×