Question about 1995 Chevrolet Lumina

1 Answer

Electrical problems my brake lights nor my signal lights work on my car do any one know wat i should dew

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 185 Answers

Check all your fuses. Chances are you blew one.

Good luck to you.

SIncerely,

jC

Posted on Jan 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I replaced the signal light switch and the brake light switch on 1991caprice an brake lights still not workn wat else could it be.


Hi Joe:
Since the rear brake lights and signal lights are on the same circuit, I'd be looking for a common problem and start with the fuse. A voltmeter is really helpful in tracing the "flow" of power from where you know you have it, to where it has to get to.
I'm assuming that both left and right sides are not working? How about the front signals? If they're not working you definitely have a power supply problem.
Anything happening at the signal solenoid?

Aug 01, 2015 | Cars & Trucks

Tip

Both Lower Brake Lights Not Working


Check Brake Light Bulbs: All cars have three brake light bulbs that create the brake light illumination affect. If the lower two bulbs fail no lower brake light operation will occur. I know what you're thinking, you might say two brake lights at once? But in reality one brake light went out at a time and you did not notice. People only tend to notice something when they almost run into the back of your car to help persuade them to inform you the brake lights aren't working. Remove either of the brake light bulbs to confirm the bulb is ok or burned. After the bulb has been removed inspect the filament and replace if failed. If the brake light bulbs are ok continue to the next step.

Checking the Turn Signal Switch: Most American cars are designed to have the brake light switch wiring intergraded into the turn signal switch. Because the brake light bulb and the turn signal bulb are one and the same the turn signal switch interrupts the brake light circuit and installs the blinker signal circuit when the turn signal switch is activated. If this switch fails it will not allow the brake light signal through to the brake light wiring. To test for this condition a car repair manual is needed to test incoming and outgoing electrical current. If brake light switch power is present at the turn signal switch but not at any outgoing brake light wires the turn signal switch has probably failed.

on Dec 18, 2009 | Honda Civic Cars & Trucks

1 Answer

How do i go about my tail lights not working? Everything else works signal,brakes,headlights all work but no tail lights? Do u know wat could be the problem


Are the front park lights operational? These are tied into the tail lights as well. If the front park lights are operational and the rear are not, suspect bad/burned out bulbs. If no park lights operational, suspect fuse or wiring

Jun 06, 2015 | Cars & Trucks

1 Answer

I just bought the car the turn signals work in the front but not in the back whats the problem?


Have you checked the bulbs already?
Don't know what kind of car you are dealing with here.
Most vehicles - the brake lights and rear turn signals share the same electrical circuit to the rear tailights. Usually the turn signal switch will separate which signal goes to the back.
Do your brake lights work? Is there a High mounted stop lamp and does it work?
I have seen a Hazard Switch be ON and fuse blown causing the Hazard Flasher to be inop - which prevented the turn signals from working. Turning OFF the hazard flasher brought back the T/S.
Check the rest of the lights - see what does and doesn't work - and do the front turn signals flash? Stay On? Or flash really slow?
Let me know what you find out and if this helps you at all.

Mar 12, 2015 | Cars & Trucks

1 Answer

2000 Chevrolet Cavalier Turn Signals not working and brake light goes out when turn signal switch is flipped on Brake lights work without turn signal flipped on.


You say you replaced turn signal switch, Have you changed the relays for this? Also check chevy recalls as they have had several concerning electrical problems with these cars. The harness can also get corroded as well as the bulb sockets.

Apr 21, 2014 | 1998 Buick Century

1 Answer

Need to know how to hook up tailights wich wire is wat


Green wire is right turn signal, yellow wire is left turn signal and green and yellow are brake lights, and brown wire is parking lights.

Jan 21, 2010 | 1998 Chevrolet K1500

1 Answer

1998 Mystique brake lights don't work while the window brake light does work.


Try a continuity test, not sure where to find the electrical scheme but if you obtain it, use a tester or borrow one to test the continuity of the wires of both taillights, could be simple as a cut wire.

May 24, 2009 | 1998 Mercury Mystique

1 Answer

ALL BREAK LIGHTS NOT WORKING


Have you checked your brake light fuse? If it is good do your rear turn signals work? If you have turn signal and no brake lights it is probably the turn signal switch these are a common problem and your power for your brake lights goes through your turn signal switch. Sometimes it is actually the hazard switch that melts but this can not be serviced alone. If you have no rear turn signals and no break lights it could still be the turn signal switch but is more likely to be a wiring problem in the rear usually trailer wiring T connections. Chiltons has wiring diagrams in there manuals but they are not always accurate. Let me know if I can help you further and please rate.

Dec 27, 2008 | 2000 Chevrolet Blazer

1 Answer

Rear taillight problems


I had the same problem with my 1996 Mystique about a year ago. The brake and tail lights stopped working, except for the center brake light in the window. Turned out to be oxidation of the terminals at the connector on the turn signal. Yes, that's right, turn signal. The electrical signal to the tail lights goes thru the connector on the turn signal. To fix, I cleaned the contacts and the brake lights started working again. Hope this helps. Cheers, Henry

Nov 25, 2008 | 1998 Mercury Mystique

Not finding what you are looking for?
1995 Chevrolet Lumina Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...