Question about 1999 Chrysler Concorde

2 Answers

I can't find my brake fuses i need help to fix my brake lights

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Need to change the brake light but cant find where to put the bulb.

Posted on Mar 13, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 106 Answers

Tell me what exactly your brake lights are doing??

Posted on Jan 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My brake and battery lights are both on my 2008 nissan maxima will go faster than 40 mph, what is wrong?


Battery light on may mean alternator is not charging, thus engine is running off only battery power = weak spark and bad curent to ECM. Fix battery issues and should run better. Brake light separate issue I think.

Jan 29, 2015 | 2008 Nissan Maxima SE

3 Answers

Brake Lights don't work on the back of our 2003 Ford Windstar


Did you actually check the brake light switch for power in and out ?
There are two different fuses, one for each side. And the circuit includes the turn signal switch.
The third brake light bypasses the turn signals.

Mar 01, 2013 | 2003 Ford Windstar

1 Answer

I need to find the fuse that will turn off the emergency brake light on the dashboard, but that particular fuse isn't listed?


WHAT??? ARE YOU NUTS???

THAT LIGHT IS ON TO TELL YOU THAT YOU HAVE A BRAKE SYSTEM FAILURE!

The fix is NOT removing the fuse! The fix is to properly diagnose the reason that the light is on and get it repaired before somebody gets killed!

Mar 11, 2012 | 2002 Chevrolet TrailBlazer

1 Answer

Brake lights are out, the cab brake works but not the tail ones. Bulbs are good cause turn signal works, fuses don't appear bad and need to ck brake switch and replace to see if fixes. Please help!!!


THE FUSE FOR THE BRAKE LIGHTS MAY BE LABELED " STOP ". GM USES BRAKE FUSE FOR THE " ABS " HOWEVER, THE FUSES NEED TO BE TESTED WITH A FUSE / CIRCUIT TESTER, IN THE FUSES BOX UNDER THE HOOD & THE FUSE BOX INSIDE THE VEHICLE.

Jan 09, 2011 | 2005 Chevrolet Silverado

1 Answer

Yesterday my back brake lights both went out. How do I fix the problem? Thank you, Yvonne


Hello Yvonne:

1st thing to check is your Fuses, Could be that its only a Blown Brake Light Fuse.

If your Brake Light Fuse is good ,Then i would Try to put New Bulbs in and see if its That for some reason both bulbs just happen to burn out at same time.

And if still no Brake Lights you'll need to Replace your Brake light switch,which is located drivers side under dash mounted to the Brake pedal Metal part up above where you push the brake pedal.

You'll see the wiring that connects to the Swith,Just pull off the wire connector and remove the brake light switch.

Yvonne this will get your brake lights working.

Thank you for using FixYa Please let me know how my Solution helped you out by Voting ,and a Testamony would be appreciated.
Thanks Again From d_hubbs

Aug 18, 2010 | 2005 Cadillac CTS

3 Answers

Brake lights and cruise control stopped working at the same time?


Ther is a recall on the brake light switch it makes the cruise control not work too. but Chevy only recalled the Brake lamp Switch. Recall #09049.Hope this helps.

Jan 01, 2010 | 2006 Chevrolet Colorado

1 Answer

My '89 Crown Vic keeps blowing brake light fuses. Does fine until I use cruise control then blows fuse. Still has parking lights and signals but no brake lights. Has happened repeatedly. Now I don't use...


check under the dash st the brake pedal,there is a brake light switch which is tied into the cruise control,you could try unplugging that and see if it fixes the problem(remember you will have no brake lights while it's unhooked) if the problem is gone replace the switch.

Apr 29, 2009 | 1989 Ford Crown Victoria

1 Answer

95 chevy astro van no brake lights


Check the stop light switch on the top of the brake pedal arm inside the vehicle. It may be stuck but can be checked very easily. Push the button in and out... should go smoothly and turn the lights on when depressed. Cheap to fix if that's it...

Jan 07, 2009 | 1995 Chevrolet Astro

2 Answers

No brake lights, fuses keep blowing and wont shift out of park


I would look for a wiring short in the trunk at the taillamp area, or, inspect the sockets for the taillamp bulbs for corrosion. In any case, you have a short circuit in the trunk area, also check the wire that comes from the body & goes up the trunk hinge on the driver side; that wire may be chafed, and it may be shorting out. Hope this helps; please get back to me if you need any further assistance.

Nov 04, 2008 | 1996 Toyota Corolla

Not finding what you are looking for?
1999 Chrysler Concorde Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...