This evaporator takes a professional technician over 15 hours of hard labor to replace. Hurray for BMW. This is planned obsolescence. They figure if they make it hard enough and expensive enough to work on eventually you'll buy another new car. How right they are. People who buy new cars don't care. They just keep buying this junk. The do it yourself type person should not attempt this proceedure. You'd be asking for big trouble.
SOURCE: 1998 BMW 328i Rear WIndows broken
then it is the actual buttons for the windows on the rear doors
SOURCE: 2000 BMW 328i yellow oil light on but oil is fine
Your sensor is going bad or you have to change your oil.
SOURCE: 2009 BMW 328i engine light - air in gas tank...
the gas tank pump is malfuctioning or the check valve on the evpaerative canister purge valve is malfunctioning.
SOURCE: BMW 328i Starter how to replaice
1999 BMW 328I 2.8L EFI DOHC 6cyl
Starter - Removal & Installation
The
starter motor on some models is very difficult to see from the top of
engine compartment as it is covered by the intake manifold. On these
models, without removing the intake manifold, the starter motor must be
removed from underneath the vehicle. Because the starter motor mounting
bolts are not easy to access, a long extension with a universal joint
mounted on a proper sized socket could be used. A three foot
transmission extension is commercially available from tool vendors that
has a 3
/
8
inch drive of the driven end and
1
/
2
inch drive on the drive end. If used with a non-binding impact
universal joint and a proper fitting impact socket, the starter motor
fasteners can be removed from underneath the vehicle.
Once the starter motor fasteners are removed, the
starter motor may have to be moved side-to-side several times to loosen
the dowel pin if it has corroded in place.
NOTE
When the battery is disconnected, the radio code, on-board
computer and clock settings will be lost. The radio code should be
obtained before disconnecting the battery or radio. Once the battery
has been reconnected, the radio will not function unless the code is
keyed in.
Starter motor electrical terminal fastener torque specifications for all models:
M5 terminal fasteners: 44 inch lbs. (5 Nm)
M6 terminal fasteners: 53 inch lbs. (6 Nm)
M8 terminal fasteners: 115 inch lbs. (13 Nm)
Starter motor mounting fasteners:
Hex head bolts: 36 ft. lbs. (49 Nm)
Torx bolts: 32 ft. lbs. (43 Nm)
Starter motor electrical terminal fastener torque specifications for all models:
M5 terminal fasteners: 44 inch lbs. (5 Nm)
M6 terminal fasteners: 53 inch lbs. (6 Nm)
M8 terminal fasteners: 115 inch lbs. (13 Nm)
Starter motor mounting fasteners:
Hex head bolts: 36 ft. lbs. (49 Nm)
Torx bolts: 32 ft. lbs. (43 Nm)
E36 6-Cylinder Engines
Automatic Transmission Models
Manual Transmission Models
Fig. A view of the starter motor mounting fasteners and dowel pin. The mounting bolts are threaded into the starter motor
Fig. The starter motor mounting bolts are a different size than the transmission-to-engine mounting bolts
I hope help you with this (rated this help) Good luck.
SOURCE: how do I remove 2009 BMW 328I front headrest
Pull the headrest up to the most extended position, tilt it all the way forward, then you will want to **** or yank upwards slightly to clear the last little groove. Pull up on the chromed stalks, one at a time. This should work. Once you know how much force to apply the first time, it's a snap afterwards.
397 views
Usually answered in minutes!
×