Question about 1999 Mercury Villager

1 Answer

Power window trouble

I have a 1999 mercury villager, the driver side window will go down but not back up...I am sure I need a new motor for it, but right now I just need to know how to get it up, until I can get a new motor for it. Please help!

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Your motor is probably fine. The problem is the switch. Mine did the same thing about 50,000 miles ago. You can easily take apart the switch and clean the small metal contacts. That should work for a while. Mine stopped working again and I had to replace the switch module. Less than $100 for a new one, probably even less if you can find one in a junk yard. To remove it just take out the phillips screw at the bottom of the door pull and the whole trim piece comes out with thte switch. Unplug it and carefully take it apart. Good Luck.

Posted on Feb 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix my Mercury Villager 2002 with random misfire?


How to Fix error code P0300 for random misfires on your car ...

diy-auto-repair.wonderhowto.com/.../fix-error-code-p0300-for-random-...
Oct 15, 2010 - How to Fix error code P0300 for random misfires on your car ... amisfire (code P0304) on a 1999 Mercury Villager 3.3L ยท How to Fix error code P0500 ... I reset my codes and it ran fine for a couple of days, then I started getting ...

(code P0305) on a 1999 Mercury Villager 3.3L - auto repair

diy-auto-repair.wonderhowto.com/.../troubleshoot-misfire-code-p0305-1...
Sep 7, 2010 - The vehicle is a '99 Mercury Village, 3.3L, with 150000 miles on it. The chief ... How to Fix error code P0300 for random misfires on your car ...

2000 Villager Misfire - Car Forums and Automotive Chat ...

www.automotiveforums.com > ... > Mercury > Villager
May 24, 2010 - 2000 Villager Misfire Villager Car Forums. ... i was told that the 3.3L engines of 1999-2002 nissan quests/ mercury villagers are INTERFERENCE engines! ... Hope the following may help, and I will post if my last fix works. ... I have a 1999mercury villager that is showing a random multiple cylinder misfire ...

Rough Idle - 2000 Mercury Villager - RepairPal

repairpal.com > Questions > Mercury > Villager > 2000 Mercury Villager
Repair the code issue, because your Villager has OBD-II which is a very helpful Diagnostic system. Upvote (4) ... My 1999 Villager was running poorly; rough idle, lack of power at highway speeds and the engine problem light indicated random miss-fire, etc. I had new spark ... Have code po306 cylinder 6 misfire detected.

P0301 - OBD-II Trouble Code - RepairPal


Dec 17, 2015 | 2002 Mercury Villager

2 Answers

Where is the power window relay located in a 2002 mercury villager?


Principles of Operation
The driver power window regulator motor is controlled directly by the master window/door lock/unlock switch (and its integrated "auto down" module). Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The driver power window regulator motor is a reversible motor that is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The passenger power window regulator motor is controlled directly by the passenger power window switch and can also be controlled by the master window/door lock/unlock switch. Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The passenger power window regulator motor is a reversible motor, which is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The power rear quarter glass is also directly controlled by the master window/door lock/unlock switch. The power rear quarter glass power latches also utilize reversible motors. The power rear quarter glass power latches are operated by applying power and ground to the motor leads to open the window, and then reversing polarity on those same leads to close the window.
Visual Inspection Chart Mechanical Electrical
  • Improperly aligned window
  • Damaged window mounting
  • Window frame interference
  • Central junction box (CJB) Fuses:
    • F30 (10A)
    • F32 (20A)
    • F34 (20A)
    • F59 (7.5A)
  • Battery junction box (BJB) Fuses:
    • F20 (30A)
    • F27 (45A)
  • Switches
  • Circuits
  • Connectors
  • Heated back light
  • Relays
Which window is not working ?
  • Single power window is inoperative
  • Front door power window switch.
  • Front door power window regulator.
  • Circuit.
  • Driver door power window switch.
  • GO to Pinpoint Test B .

Apr 07, 2015 | 2002 Mercury Villager

1 Answer

1999 mercury villager drivers side power window doesn't wirk


before replacing the relay, check the windows switch. and may even be able to just unplug it, and double check it is all the way connected really good. I would bet 99 % its the switch.

Mar 01, 2014 | Mercury Villager Cars & Trucks

1 Answer

None of my power windows work on my 99 Villager.


make sure you did not accidently hit the lock out switch on driver door controls for windows. Relay is behind fuse panel.

go to villager quest yahoo group for much morehelp

gerry

Aug 03, 2011 | 1999 Mercury Villager

1 Answer

Windows on left side front and back want go up or down I need help


go to our site, free expert help. could be motor or switch. make sure lock out button is not pushed on driver door switch panel.

http://groups.yahoo.com/group/villagerquest/

Jan 10, 2011 | 1996 Mercury Villager

1 Answer

Drivers window stuck in down position


u need to replace the window motor

Jul 10, 2010 | 1995 Mercury Villager

1 Answer

Help!! I've got a 97 Villager (like the Nissan Quest) with window problems!!


when the widow is down, take some spraylube and spray into the tracks on either side of the window. see it that makes any difference

May 26, 2009 | 1997 Mercury Villager

Not finding what you are looking for?
1999 Mercury Villager Logo

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...