Question about 1998 Dodge Caravan

1 Answer

Out put speed sensor

Where is situate output speed senser on a caravan 98 3 litre 3 speed

Posted by on

  • jean_10 Jan 18, 2009

    but i don't have a speed cable it is electric

    jean

  • jean_10 Jan 19, 2009

    i found it is rear transmission and we must keep the small gear and reapply at the new sensor.tank 's for help

    Jean

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

It should be mounted on the transmission at the end of the speed cable.

Posted on Jan 18, 2009

  • Ward  Messervy
    Ward Messervy Jan 19, 2009

    It still should be mounted on the transmission. with or without a cable.

    Let me know so I can up date my books


×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan Caravan van 2 litre petrol engine plus automatic transmission consuming more fuel than expected.


have you had the OBD code read if not get this done at a garage this will def give you a starting point at the very least

Apr 04, 2014 | Nissan Cars & Trucks

1 Answer

I change this of my 98 Dodge caravan but I'm still


The ****** is slipping the sensors are just reported that it is slipping, this sets a fault code, it doesn't means the sensors are defective as you found out. You will need to rebuild the transmission is my guess.

Sep 20, 2012 | Cars & Trucks

2 Answers

I have a 1994 dodge grand caravan with a 3.8 v6 the transmission get stuck in second gear after driving for 30 min was told it could be a speed sensor


The speed sensor could indeed be preventing the van from switching gears. Have this checked into or you could do it yourself by reading this article and following the link it provides for testing. http://www.engine-light-help.com/speed-sensor.html

Hope this helps:)

Jan 24, 2011 | 1994 Dodge Grand Caravan

1 Answer

97 Dodge Caravan Sport Once it warms up it stays in second gear until i put it on nutural- shut vehicle off- and then restart it and it will shift fine. What could it be?


The transmission is going into failsafe mode, meaning the computer is seeing an electrical problem and turning off all solenoids locking it into on gear. Best bet is to get a scan tool and read the codes in the transmission module, common problems are the input and output speed sensors. If you are having problems with the speedometer, you probably need an output speed sensor. I've also had problems with pressure switch codes that have lead to replacing the valve body. If you have a speed sensor code i recommend replacing both the input and output speed sensors, they screw into the front side of the transmission.

Oct 16, 2010 | 1997 Dodge Grand Caravan

2 Answers

I am driving a 1992 Dodge Grand Caravan. And my speedometer stoped working. What do I do?


you can scan it,and see what the output speed sensor is putting out.most times you will have a bad vechicle speed sensor

May 09, 2010 | 1992 Dodge Caravan

4 Answers

1996 dodge grand caravan transmission will not shift out of 1st gear, speedometer doesn't work either


Mounted on the trany is a speedometer sensor. The vehical will not up-shift it, sensor, is malfunctioning. The vehicles computer doesn't know that it is not going fast enough to change gears.

Dec 08, 2009 | 1996 Dodge Caravan

1 Answer

I have a 1996 dodge caravan with the 3 speed transmission and i need to find out the exact location of the input and output speed sensors thanksi


A 3 SPD TRANS DOES NOT HAVE INPUT/OUTPUT SENSORS..ONLY A VEHICLE SPEED SENSOR..IT IS LOCATED ON TRANS EXTENSION HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..1 BOLT AND A WIRE CONNECTOR

Jul 18, 2009 | 1996 Dodge Caravan

2 Answers

Transmission input output speed sensors


The speed sensor is on the tailshaft of the transmission,on the passenger side of the car,it has 3 wires. The output sensors are located on the front of the transmission about mid-way up the housing & only have 2 wires. Note the output sensors are not responsible for vehicle speed. Only the output shaft speed is recorded. They are for finding the correct cvi(clutch volume index) only. If you have a cvi issue,the transmission is toast.

Jun 26, 2009 | 2001 Dodge Caravan

1 Answer

1996 Dodge Caravan with 76000 will not shift out of first gear.


is engine light on?may have a faulty input or output speed sensor or solenoid pack..should have trouble codes..if it's 3 speed trans,possible internal problem..need to know if it's 4speed or 3 speed trans

May 09, 2009 | 1996 Dodge Caravan

1 Answer

What cause a transmission lever not to shift to L on 98 caravan?


Shift Cable Hun if u go Under your ZVan Find your Tranny what thay have Done is not Put the Cable back where it needs to Be Or thay Put a ZBad Pin back in if it is a Pin u can get them Cheap enoff Prolly like 5 to 10 Bucks

Feb 01, 2009 | 1998 Dodge Caravan

Not finding what you are looking for?
1998 Dodge Caravan Logo

Related Topics:

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...