Question about 1985 Jeep CJ7

1 Answer

Why does my cj7 choke out in water

1980 cj7 4cylinder

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.
    Corporal:

    An expert that has over 10 points.
    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Get a snorkel if intake is submerged under water

Posted on Jan 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

6ya.com

Download 6ya

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1983 jeep cj7 258 acid. won't start. It turns over but won't fire up. Wondering if leaving key on for 30 min without running might have messed up the distributer?
Could have messed up a lot. Check the coil, points, condenser, and choke pull-off if it's electric. Some auto chokes have an electric heater, check for that, too. I'd just get a new condenser and points.

Nov 29, 2013 | Cars & Trucks

1 Answer

Jeep CJ7 will not start when it cold
Have you checked to see if the choke is working on the carb ?

Sep 24, 2012 | Jeep CJ7 Cars & Trucks

1 Answer

Hi I just bought a 1984 cj7 6 cyl 4.2 anyways replaced water pump thermostat spark plugs wires rotor distributor hoses and it still gets hot water disappears its not coming out of exhaust no mixture in the...
Do compression check. Probably blown head gasket. Chelly

Aug 13, 2011 | 1984 Jeep CJ7

2 Answers

Choke stuck open on 83 CJ7. Choke plate has no "spring" resistance, just flops back and forth. Solutions?
the linkage from the choke knob to the carbeurator is likely disconnected, check the linkage at the carb and follow it back from there to find where it came apart.

Apr 01, 2011 | Jeep CJ7 Cars & Trucks

1 Answer

Ok my 1986 Jeep Cj7 straight six has had trouble starting I deserned the electronic choke was moving freely I would turn it back and forth to get good idle rpms I went to O'Riellys and got a new...
buy a haines manual,sometimes its better that the chiltons.

Oct 22, 2010 | 1986 Jeep CJ7

1 Answer

Torque setting for water pump bolts for 1984 jeep cj7 4 cylinder
25 TO 28 FOOT LABS

Jan 27, 2010 | 1984 Jeep CJ7

1 Answer

1979 cj replased carb idles tohigh
Even with a rebuilt carb you have to make the adjustments. Check the choke adjustment and set the fast idle. If choke is to tight it will be hard to start and take a long time to idle down. The fast idle sounds like it is high also.

Oct 01, 2009 | 1983 Jeep CJ7

1 Answer

Need to know what wires go where on my 78 cj7 fuel and temp gauge?
Fuel wire goes to the Gas Tank and Temp gauge goes to the thermostat located near the end of water pipe from radiator.

Sep 06, 2009 | 1985 Jeep CJ7

1 Answer

Need to know how to replace a water pump on 81 cj7
This is for an 82 Inline 6 Aldata doesnt go back that far, if you need further info Hit Me Back

  1. Disconnect battery ground cable.
  2. Drain cooling system.
  3. Disconnect radiator and heater hoses from water pump, Fig. 21.
  4. Remove drive belts.
  5. Remove fan shroud and fan.
  6. Remove water pump attaching bolts, then the water pump and gasket.
  7. Reverse procedure to install.

May 31, 2009 | 1984 Jeep CJ7

2 Answers

86 CJ7 will run but will not idle.
Clean the idle control valve. located just inside the hole where you remove the aircleaner duct work. use brake cleaner or carburator cleaner.run at about 1200 rpms and spry directly into the valve.

Dec 19, 2008 | 1986 Jeep CJ7

Not finding what you are looking for?

View Most Popular

1985 CJ7

  • Cars & Trucks

Related Question

My 1983 jeep cj7 258 acid. won't start. It turns over but won't fire up. Wondering if leaving key on for 30 min without running might have messed up the distributer?

  • Cars & Trucks

Open Questions:

0 Answers

REPLACEMENT OF TEMPERATURE SENDING UNIT FOR CJ7 1985 6 CYLINDER

Apr 17, 2014 | 1985 Jeep CJ7

0 Answers

power steering pump belt dont line up and is loud added power steering to a in line six and do i need bushing or what

Apr 07, 2014 | 1985 Jeep CJ7

0 Answers

1985 cj7 rear axle shim

Nov 27, 2012 | 1985 Jeep CJ7

0 Answers

how to replace a rear axle seal on a 1983 jeep cj7

Oct 21, 2012 | 1985 Jeep CJ7

See all 1985 Jeep CJ7 Questions

Related Topics

Cars & Trucks Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

1985 Jeep CJ7

1984 Jeep CJ7

1984 Jeep CJ7

1984 Jeep CJ7

Jeep CJ7 Cars & Trucks

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

71231 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7001 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 1985 CJ7 Manual

1985 CJ7

Loading...