Question about 2003 Chevrolet Silverado Ss

1 Answer

Blower motor won't shut off when I turn the truck off, and it can't control the fan speed on a 2003 2500HD

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

UNPLUG THE FUSE AND REPLACE YOUR BLOWER MOTOR SWITCH.

Posted on Jan 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Missing variable control voltage on the blower fan control module on a 2008 Buick lucerne


What are you using to test this control signal ? Were you on right wire ?
Blower Motor Control Processor The blower motor control processor is an interface between the HVAC control module and the blower motor. The blower motor speed control, battery positive voltage and ground circuits enable the control processor to operate. The HVAC control module provides a pulse width modulation (PWM) signal to the control processor in order to command the blower motor speed. The processor supplies 12 volts to the blower motor through the blower motor voltage supply circuit. The control processor uses the blower motor ground as a low side control to adjust the blower motor speed.

Chevy Trailblazer EXT Blower Motor Won Turn Off The blower motor in this video don't shut off , but he show's how to test the PWM signal right !
Your blower motor control module is probably bad , or HVAC control panel is bad , or a wiring problem !

Sep 26, 2016 | 2008 Buick Lucerne CXL

1 Answer

Fan won't turn off


If the vehicle is equipped with dual climate control system ir : seperate temperature control for the passenger and driver and the speed is non-adjustable then the issue is with the high speed control relay module. This is under the right passenger compartment and located behind the blower motor slightly to the left and has 6 or 7 pin connector. They are typically called blower motor resistors. the factory blower speed contro; module is held to the heater control box using plastic welds so there is a need for 2 8 millimeter self taping screws when replacing the unit. The unit (module) cost is roughly $48.00 at AutoZone and is not very difficult to replace.

Jul 22, 2013 | 2005 Chevrolet Impala LS

1 Answer

My 2005 yukon has no ac blower fan control


check the resister next to the blower motor they burn out

Sep 25, 2012 | 2005 GMC Yukon

2 Answers

Ac fan switch won't turn on fan motor, was at one point just not turning on position 4 but now none will activate the fan motor


This is very common, this sounds like the blower resistor went bad, the blower resistor is what controls the fan speeds, the is located on the heater box next to the blowermotor, its held in with two screws and slides into heater box, lets see if i can send you a photo of the blower resistor to help you locate it.johnjohn2_107.jpg

Jun 14, 2011 | Chevrolet 1500 Cars & Trucks

2 Answers

01 grand.prix ac fan switch only works on high. has a duel temp controller when you turn fan off the only way fan comes back on is to move the temp controller levers


Hi!!
When the Blower Motor Resistor (controls blower speeds) goes bad, the blower motor works only on HIGH SPEED. REPLACE IT.
BLOWER MOTOR RESISTOR Removal & Installation
  • Disconnect negative battery cable.
  • Remove right lower instrument panel insulator panel.
  • Disconnect blower resistor connector located behind right side of dash.
  • Remove blower resistor screws and blower resistor.
To install, reverse removal procedure
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 18, 2011 | 2001 Pontiac Grand Prix

3 Answers

The heater/ac fan only works on speed settings 4 & 5


you might check your switch sounds like to me that your two lower speed sides of the switch maybe burnwed out.

Dec 19, 2009 | 2002 Chevrolet TrailBlazer

2 Answers

2002 Honda Odyssey fan only works at high speed. The A/C compress


Usually when the blower fan only operates on hi speed, its because of a failed blower motor resistor. You still have hi speed because on hi, the power going to the blower motor goes directly to it, as opposed to the lower speeds, when the power is routed through the resistor, thus lowering the voltage, which in turn lowers the speed of the fan. The resistor is usually located near the blower motor itself, under the hood back near the firewall.

Aug 15, 2009 | 2002 Honda Odyssey

2 Answers

2007 yukon rear blower runs when truck is off?


your car is possesed treat it good it will treat you good. dont worry the only time my car will start is when a chick turns the key my car is a **** lol.

Jun 13, 2009 | 2003 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...