Question about 1991 Honda Accord
I am tryng to remove a factory Honda radio in a 1991 Honda Accord LX 5 speed.
Can any one tell me how to remove the bezel around the radio or any schmatics would be very helpful.
Start by removing the console. there should be four screws that hold it in; two on each side; one in the front and one in the rear. you may have to take the gearshift knob of if the car is manual trans.then, remove the ash tray. there are two screws at the front of the ashtray receiver and one at the back.with the ashtray and slide removed, take the bezel off of the radio. there should be two screws behind or above the air outlet vents on top andn two screws in the under the center dividing rail. you may have to pop out the air outlets to get to the screws. there may also be a screw at the bottom of the bezel in the center.with the bezel removed the only thing that holds the radio in at that point is two screws that come up from underneath where the ashtray receiver was. take out those two screws and the radio should pull out from the front. Be sure to disconnect the antenna lead and the connector from the back of the radio before pulling on it too hard or you'll damage one or the other.hope that helps
Posted on Jan 17, 2009
Tips for a great answer:
Jul 03, 2013 | Cars & Trucks
Aug 28, 2012 | 1990 Honda Accord
Nov 01, 2011 | 1991 Honda Accord
Apr 24, 2010 | 1991 Honda Accord
Apr 04, 2010 | 1991 Toyota Tercel
Nov 04, 2009 | 1991 Honda Accord
Jul 17, 2009 | 1991 Honda Accord
Jan 23, 2009 | 1991 Honda Accord
Jul 17, 2008 | 1991 Honda Accord
847 people viewed this question
Usually answered in minutes!