Question about 2005 Chevrolet TrailBlazer

1 Answer

Replacing driver's side panel for seat controls 2005 trailblazer

Hi there,

I've purchased a replacement cover for the driver's seat power controls (the clips broke and it was dangling) for my 2005 trailblazer. The problem I have is I do not know how to remove the controls (are they clipped on screwed on, etc) in order to remove the old cover. Any ideas/diagrams would be greatly appreciated. I certainly don't want to break the controls and have to purchase additional parts

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 391 Answers

THER ARE A COUPLE OF CLIPS THAT HOLD IT DOWN IN THE FRONT AND SCREWS IN THE REAR.THE PLUG IS HOLDING THE REST.BE CAREFUL,THERE ARE A LOT OF PINS ON MOST PLUGS.

Posted on Jan 17, 2009

  • jakeluda Oct 22, 2010

    1 front screw on panel. Take off first round control with a flat screwdriver lift clip up and pull on the plastic by the wires. Next up it is easier to pop that round control out completely. Place a flat head screwdriver in between the black electronic and the plastic and pry. U can push in on the outside of the round control to pop it out. Now u have room to disconnect the second wires. In between the wires and the plastic there is a clip that u can press with your thumb and pull. Use a flat screwdriver to push bottom of the wiring harness to help get off. Now put the new on.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the fuses for heated seats on 2004 chevrolet trailblazer lt


flip up the back seat on the driver's side. take black cover off the fuse box panel and look at the fuse location on the fuse map. It's all there. The seats just flip up. Good luck let me know how you make out

Mar 02, 2015 | 2004 Chevrolet TrailBlazer

2 Answers

Where is the fuze for theated seats in a 2003 chevy trailblazer


Most Chevys have two fuse blocks. Heated seats power windows and other interior options are in a panel on end of dash. Open drivers door and look at dash end should be a removable cover with fuse guide posted on its inner surface.

Feb 15, 2015 | 2003 Chevrolet TrailBlazer

1 Answer

Remove panel on drivers seat to replace panel


The larger connector may have wires attached to it and plug in ubder the seat. Hope this helps

Sep 26, 2014 | 2005 Chevrolet TrailBlazer

1 Answer

2005 mercury grand marquis driver air bag circut open after replacing airbag,clock spring,and control module


You need to have the system checked for what the fault code is...are you sure it's the drivers side air bag or the drivers side, side air bag(located in the seat back?)They're could be a problem with the wiring under the seat.

May 12, 2014 | 2005 Mercury Grand Marquis

1 Answer

Drivers door control panel (power window heated seat locks ect ) what to do none of it is working 2006 chevy trail blazer


Check fuse #10 in the rear fuse panel. If fuse OK, try switching passenger side control module into driver's side. Also check for broken wires in wiring harness that goes between body and driver's door.

Sep 03, 2011 | 2006 Chevrolet Trailblazer

1 Answer

Hello! I have a 2005 Cadillac CTS-V Both the right and left brake lights stopped working at once. The center brake light on the trunk still works. I was googling to see how to change the bulbs but it...


I assume the solution is the same in a CTS as a CTS-V. Remove the plastic molding facing the rear. There are four plastic screws, Unscrew and lift the spare tire cover. Unscrew plastic screws on carpet covering quarter panels pull back for room to work. Each light assembly has two nuts, remove these and assembly will slide out for easy replacement. Since both lights stopped at once, the fuse may be the issue. The fuse box is under the rear seat cushion, behind the driver. Pull the seat up and forward. Pull levers out on each side of fuse box cover and lift. The diagram is inside the fuse box cover. It'll take a 15V. Note: Please take care in replacing and seat and proper seat belt placement. While you're in the backseat, check all the fuses, there's a second fusebox on the passenger side. Also, check floor behind driver's seat for wetness and water. That could cause a short as well. Good luck!

Nov 14, 2010 | 2005 Cadillac CTS

1 Answer

I have a 2006 chevy trail blazer, the drivers side door, will not lock or unlock, the electric windows will not operate , or the drivers side and passenger side mirrors will not adjust using the controls...


Problems WithChevy TrailBlazers
ElectricalProblems
Some of the mostcommon problems with the TrailBlazer involve the vehicle's electrical systemand accessories. Many drivers have experienced problems with the dashboardgauges, including the fuel gauge, speedometer and "check engine"warning light. Additional electrical problems include power automatic doorlocks and windows that fail to work or operate intermittently. These problemscan be difficult to diagnose as they can result from anything from a faultybattery to problems with the wiring or other electrical components.
Read more: Problems With Chevy TrailBlazers ' eHow.com A fuse contains a thin metal bridge between two terminals. When too muchelectrical current is drawn through the fuse the bridge melts, breaking thecircuit. This feature prevents damage to electrical components and limits thepossibility of a fire.The Chevrolet Blazer utilizes small fuses to protect thevehicle's wiring harness from overload. These are typically plug-in blades, notthe glass-barrel fuses used in older vehicles.
Location The fuse panel ona Chevy Blazer is located on the driver's side of the firewall beneath thedashboard. Some later models may be equipped with a fuse panel cover. To removethe cover, pull the retaining clips loose on each side and lift the cover fromthe panel. Replacing a Fuse Locatethe fuse you believe is burned out by its label or use the owner's manual as aguide. To remove the fuse, you may need needle-nose pliers; don't put too muchpressure on the fuse or you could crack the casing. Examine the thin metalstrip between the two terminals. If it is broken, scorched or deformed, it mustbe replaced. Read more: Fuse Box Instructions for a Chevy Blazer ' eHow.com

Nov 09, 2010 | 2006 Chevrolet Trailblazer

1 Answer

What is involved in replacing a heating element in the front drivers side seat of 05 montecarlo SS


remove the seat and you have to remove the bottom seat cover material but first check your power relays and wires to make sure the relay has voltage to the seat heater and check the seat ground as well

Jan 13, 2010 | 2005 Chevrolet Monte Carlo

Not finding what you are looking for?
2005 Chevrolet TrailBlazer Logo

1,188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...