Question about 1993 Pontiac Grand Prix

1 Answer

I want to replace driver window, how is the quickest way

Thats all i need to know.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has answered 200 questions.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 217 Answers

Lower window 3-5 inches tape window to top of door so window will not fall take off door pad remove nuts that hold window to the regulater,lower regulator by the switch and then carefully wiggle window out after removing tape.

Posted on Jan 17, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2001 oldsmobile aurora 3.5 moter , i need to know the hose layout of the moter

Go to Your local Library and check out a Chiltons repair manual for that Vehicle that will be the quickest and cheapest way to learn it's locations and routing.

Jun 22, 2016 | 2001 Oldsmobile Aurora

1 Answer

1999 Isuzu rodero driver side window how do I check to see if window motor needs to be replaced

quickest way is to check for power to the switch. If you have power on one wire (any wire) and ground on a wire (any wire)... try a new switch. Either the window will operate or you need a new motor.

Dec 17, 2014 | 1999 Isuzu Rodeo

1 Answer

How would you remove the ac compressor from underneath the vehicle? Trying to replace it and would like to know the easiest, quickest way....

the system is pressurized with compressed refrigerant, and is illegal to release into the air. you must have a license to work on these systems. take it to a repair shop.

Dec 09, 2014 | 2000 Oldsmobile Silhouette

1 Answer

2006 Dodge stratus power Windows not working. They first started by stopping half way thru rolling up or not rolling up at all. I could just open and shut the driver door and sometimes they would work...

common problem on these cars and others. the wires that run from the body to the door bend too many times and break. they are inside the rubber cover. you can replace the wiring harness or you can splice them back together with some heat shrink will need to pull the rubber back on the harness far enough to look for broken wires first. if you replace the harness you will have to remove the door panel and some other stuff to get it out and you will have to unplug it from the connector at the body. the quickest, easiest way is splicing.

Oct 04, 2014 | 2006 Dodge Stratus

1 Answer

How to replace rear door window on 93 pathfinder

If you can see the edge of the glass (not stuck inside a rubber mould) then the glass will be glued to the body. The quickest and easiest way for you to get a water proof job without the mess is to have a windscreen shop fit it for you. Believe me you do not want the hassle.

Dec 12, 2013 | 1993 Nissan Pathfinder

1 Answer

How to trouble shoot power window on 2005 titan

Quickest way is to hit the door panel around the center of door panel while working the window switch and the motor should start to move

Dec 26, 2012 | Nissan Cars & Trucks

1 Answer

Drivers side window

The glass should bolt to the window channel on the bottom of the window. Roll the window all the way up and duct tape it to the top of the door.

Dec 15, 2008 | 2004 Dodge Caravan

3 Answers

97 cadillac deville power window motor replacement drivers side

The motor sit on a gear stem you will have to wiggle it a little to get it off the magnet inside is holding it to the window frame just use a little pressure to remove.

Jul 16, 2008 | 1997 Cadillac DeVille

Not finding what you are looking for?
1993 Pontiac Grand Prix Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides