Question about 2006 Ford Fusion

1 Answer

Check engine light on

I had my check engine light come on and it is reading 3 codes...P0010, P2104, and P2112. Any idea what these mean. I feel like I am lost on this.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 235 Answers

The last two codes you rote have somthing to do with the electronic throttle control. the gas control is no longer controlled by a gas cable but is now all controlled electrical. so this is not a self fixer. must be checked by dealer or someone that knows what thay are doing.

Posted on Jan 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 Lincoln Ls engine codes p2104 p2112,wrench on dashboardso I drove it without problems went to Autozone to put computer scanner on car wrench came back on dash now can only drive 6 mph no go


Check coil #3 on v6 and #4 on v8. Usually the coil closet to passenger read side of engine. You probably dont feel a misfire, but put the car in drive and firmly hold brakes down. Rev to about 2k or 3k rmps. If it stutters thats your issue.

Nov 06, 2015 | Lincoln Cars & Trucks

1 Answer

04 Lincoln ls wrench on dash,won't accelerate past 6mph codes p2112 p2104


The slow drive is the car on limp home mode. This happens with codes p2104 p2112. The throttle body with new TPS needs to be replaced.

Nov 06, 2015 | Lincoln Cars & Trucks

1 Answer

What is a code 872


What Is Ford Codes P2104 P2107 P2110? Askiver - Questions

https://www.askiver.com/what-is-ford-codes-p2104-p2107-p2110.html
2008 Ford F150: P2107 and P2110 Log In Log In: User Name: Remember Me? .... DTCcodes P2104, P2112 - Ford Shelby GT500 ForumDTC codes P2104, P2112 Performance Modifications ... Two are FORMBY FORD TEL 01704 872 108 , .

Nov 04, 2015 | Ford Shelby GT500 Cars & Trucks

1 Answer

Where is Manifold Absolute Pressure/Barometric Sensor located on 2006 Ford Explorer?


Having similar trouble. Started with 12 codes now after replacing fuel pump and vapor management valve I still have 3 codes P2112 P2104 and P0451. Starts right up but idles very rough little response to pedal. I replaced tps and throttle body motor no change. Is it possible I need to have the PCM flashed? Any help or resolve to someone else's problem helps. Thanks!

Apr 29, 2012 | 2006 Ford Explorer

1 Answer

I have a 2006 Ford Expedition and I just filled the vehicle up with gas when the check engine light came on the next day. Also, the fail safe mode light illuminated. I took the SUV to Auto Zone where they...


Replace your gas cap,Disconect your battery for 30 seconds (if you have secure anti-theft system follow instructions for disconecting the battery found in your owners manual.Reconect your battery codes will be cleared.

Mar 22, 2011 | Ford Expedition Cars & Trucks

2 Answers

The following diagnostic codes P2104, P2111, and P2112 the engine failure mode appears car wont move turn it off and on again and its fine with just the check engine light Happens several timesaday now


all the codes point to throttle body. clean throttle body, especially around throttle plate. check for loose wires, if problems persist. replace throttle body. p2104 is tac system forced idle, p2111 is tac system stuck open, p2112 is tac system stuck closed. clean throttle body good, and see if this fixes it. then go from there. have a good day !!

Jan 30, 2011 | 2005 Ford Five Hundred

2 Answers

P2104 P2112 P2111 My 2005 Expedition continues to cut off and the engine light comes on. After a few miles the light goes off. Then the problem starts all over again.


The p2104 code was set because the PCM had to set the idle speed, the p2112 was set to indicate that your throttle body was stuck closed. You can try to remove the throttle body and clean it, check to ensure that it opens smoothly, check the TPS connector to ensure that it is plugged in correctly, reset the light and if the problem returns, you will probably have to install a new throttle body assembly. Hope this helps, let me know

Dec 07, 2009 | 2005 Ford Expedition

5 Answers

Engine goes to idle while driving


P2104 Throttle Actuator Control System - Forced Idle
P2106 Throttle Actuator Control System - Forced Limited Power
P2111 Throttle Actuator Control System - Stuck Open
P2112 Throttle Actuator Control System - Stuck Closed
P2135 Throttle/Pedal Position Sensor/Switch “A” /"B" Voltage Correlation
I looked it up and I will give you a web site I got it from http://www.f150online.com/forums/v8-engines/280570-p2104-p2106-p2111-p2112-p2135.html I hope this helps

May 25, 2009 | 2004 Ford Explorer

2 Answers

My check engine light has come on for my 2006 Ford Fusion and 3 codes came up...P0010, P2104, and P2112. Any ideas what these mean?


Fuel and Air Metering and Auxiliary Emission Controls P2104 Throttle Actuator Control System - Forced Idle
P2112 Throttle Actuator Control System - Stuck Closed
If it's not the pedal, it has to be throttle body, senor or harness related.

Jan 16, 2009 | 2006 Ford Fusion

Not finding what you are looking for?
2006 Ford Fusion Logo

500 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...