Question about 2003 Jeep Wrangler

1 Answer

Driving lights The driving lights on yhe bumper go on and off at will.Can't find the problem.

Posted by on

  • tleder Jan 29, 2009

    If you are referring o the fog lamps, yes I have the same problem. I found that pulling the fog turn on switch at the end of the light switch arm would turn them off only to fnd that they turned back on automatically sometime later. My coworkers would tell me that they were on. I had to disconnect the hot lead to the laps so the battery would not run down. I suspect we have similar problem. Mot likely a short in the switch arm that costs $100.00 + to replace. A guess. In 12 volt systems I am always told that improper grounding is most often the electrical problem. I need an answer too.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The next time they are on try pushing in on the switch. If just a little pressure turns them off and as soon as you let off they come back on then replace the head lamp stalk switch. This worked for me on my 2003 Jeep Rubicon.

Posted on Aug 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove bumper


1. Remove rear combination light assembly. A. Remove two mounting screws. B. Disconnect electrical connector from rear side of light assembly.

2. Remove bumper assembly. A. Remove four fasteners and four retaining screws from top of bumper assembly. B. Remove mud flap from bumper assembly. C. Remove two screws from bottom of bumper assembly. D. Remove two screws from side of bumper assembly. E. Remove four bumper mounting bolts from under of vehicle.
3. Install rear bumper in reverse order of removal.

Dec 22, 2013 | 2004 Kia Sedona

1 Answer

I have a 2008 audi Q7 under 40K still under factory warranty my left bulb is out will the dealership charge me for a new bulb


There are two parts to your warranty. The drive train (engine and transmission) and bumper-to-bumper (everything else). The drive train warranty is usually longer than the bumper-to-bumper warranty. If your vehicle is still under the bumper-to-bumper warranty, they should replace the bulb for free. This is the way it worked out on my Ford Escort so I would hope Audi would do the same.

Aug 11, 2011 | 2008 Audi Q7

1 Answer

HOW TO REMOVE YHE POWERSTEERING PUMP ON A VOLVO 850


the last one i done some while ago i had to remove the front bumper ,grill and rad to get access .took me the best part of half a day as the bolts were corroded up

Feb 05, 2011 | 1996 Volvo 850

1 Answer

Check engine light on


drive it to auto zone they will scan it fo r you and give you the codes , then repair yhe bad sensor and have the codes cleared

Nov 12, 2009 | 2004 Chevrolet Monte Carlo

1 Answer

How do i replace driving light bulbs on a hyundai entourage (the small round ones in the bumper)


You should be able to just reach up under the bumper to get to the bulb. You may have to move the plastic deflector panel to get to the bulb

Sep 13, 2009 | 2007 Hyundai Entourage Limited Minivan

1 Answer

2005 chevy cobalt check engine light on


i went to advance auto and they pulled the check engine light code and they said it was just wet electrical equipment from all the rain we have had and that it would dry out in a couple of drives so they reset the code and told me to come back in if it comes back on.

Apr 14, 2009 | 2005 Chevrolet Cobalt

1 Answer

Rear Bumper Repair


screw it back on

Oct 25, 2008 | 2001 Volvo S60

3 Answers

2002-2006 Denali front bumper fit on a 2001-2006 Yukon


Yup - you may need to get the grilles and such as well...

May 18, 2008 | 2001 GMC Denali

Not finding what you are looking for?
2003 Jeep Wrangler Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...