Homelink Garage Door Opener works in-consistently on 99 Chrysler

SOME OF THE MINI-VANS HAVE A DIAGRAM UNDER THE HOOD! IT WILL BE A WHITE STICKER!

YOU NEED TO GO VERY CAREFULLY STEP BY STEP.

IS THE IGNITION KEY TURNED TO THE CORRECT POSSITION

AFTER YOU PROGRAM THE VISOR YOU NEED TO PROGRAM THE GARAGE DOOR OPENER TO ACCEPT THE VISOR.

YOU CAN GO TO HOMELINK.COM FOR HELP - THEY MAKE THE SYSTEM AND HAVE VERY GOOD INSTRUCTIONS ONLINE

HOPE THIS HELPS

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

The best thing that you can do is get the owners manual for your car and follow the instructions. For my Jeep linked to a Genie Door the steps were:
1. Clear the existing memory by holding the first & third button at the same time for 20 seconds. 2. Remove the cover on the opener so that I could push the transmitter link button on the door opener. 3. After pushing the button on the opener I had to then push whatever button that I wanted to program on the homelink in the car. (This has to be done several times if you have a rolling code door opener). 4. Repeat as necessary for each opener/homelink you are trying to program.
Again the best thing to do is get the owners manual for the car and follow the directions.
Good luck!

If you have a hand book that comes with the van the instructions are in there. on the top panel you have one two or three dots on a switch you have to hold the garage opener next to the switch in the van press both together until it flashes .

Sorry, the process is simple but too lengthy to post here.

Goto homelink.com

They make the system and have very complete instructions you can download.

PLEASE NOTE: MOST but not ALL Brands / models of opener will work with this system.

Sorry, the process is simple but too lengthy to post here.

Goto homelink.com

They make the system and have very complete instructions you can download.

PLEASE NOTE: MOST but not ALL Brands / models of opener will work with this system.

Hi my name is Allen!

Program a previously trained homelink button as follows... 1. Press and hold the desired pre-programmed HomeLink button for at least 20 seconds (but no longer than 30 seconds) until the indicator light begins to flash. Without releasing the HomeLink button, position the hand-held transmitter 1-3 inches away from the homeLink surface keeping the HomeLink indicator light in view. 2. Using both hands, simultaneously press and hold both the desired HomeLink button and hand held transmitter button (or press and "cycle" - as described in "Gate and Canadian programming"). DO NOT release until the HomeLink indicator light flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapid flashing indicates successful programming) The previous device has now been erased and the new device can be activated by pushing the HomeLink button that has just been programmed. however, it may be necessary to follow steps 5-7 of the "programming" section to complete the rolling code training. This procedure will not affect any other programmed HomeLink buttons.

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS