Question about 1998 Toyota Tercel

1 Answer

Can't find a windshield reservoir for 98 sonata

Anyone know where I can get either used or new windshield reservoir for 98 sonata SL online ?...

Posted by on

  • rrivera60 Jan 16, 2009

    don't need to know WHERE it is....I need to know where I can PURCHASE one...but thanks for trying!

  • rrivera60 Jan 16, 2009

    not yet...i thought I would just try and find it online first. thanks for the idea though.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 6,674 Answers

Have a look on drivers fender up behind headlight area.

Posted on Jan 16, 2009

  • Mike Butler
    Mike Butler Jan 16, 2009

    Dah ! My mistake, I got sidetracked & forgot what the entire question was, sorry. Just a thought though, have you called local auto recyclers?

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the windshield washer pump on 2008 ford focus, wipers work but no spray comes out


The hose could be clogged ! Do you know where you add the washer fluid ? Somewhere on the bottom of that plastic bottle is the washer pump .
Removal and Installation
> WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on label of washer solution container. Failure to follow these instructions may result in personal injury.
> CAUTION: When replacing the windshield washer pump be careful not to damage the rubber grommet.
> CAUTION: Do not operate the windshield washer pump before filling the reservoir. Failure to do so could result in premature pump failure.
  1. NOTE: When installing the reservoir, the filler neck must be lubricated using a water-based lubricant.
    Remove the bolt and the windshield washer reservoir filler neck.
  1. Remove the RH fender splash shield. For additional information, refer to Section 501-02 .
  1. Remove the foam filler and remove the retainer.
  1. Remove the 2 screws and the accessory drive splash shield.
    • To install, tighten to 5 Nm (44 lb-in).
  1. Remove the nut, 2 bolts and position the A/C accumulator aside.
    • To install, tighten to 9 Nm (80 lb-in).
  1. Unclip the A/C lines from the inner fender well.
  1. Drill out the rivet and remove the bracket.
  1. Remove the 2 bolts, slide the windshield washer reservoir assembly forward to release it, and position the washer reservoir aside.
    • Install the upper bolt followed by the lower bolt, and tighten to 5 Nm (44 lb-in).
  1. Disconnect the windshield washer tube assembly from the pump and release the windshield washer tube assembly from the washer reservoir.
  1. Disconnect the electrical connector from the windshield washer pump.
  1. Release the wiring harness from the reservoir, and remove the washer reservoir.
  1. To install, reverse the removal procedure.

Apr 07, 2015 | Ford Cars & Trucks

1 Answer

Sonata 1996 2l twincam repair manual


Hi, I'm trying to find the same thing but for a 1998 Sonata EF. :( The internet is hopeless too! They keep saying their not available anymore from 96 to 98. Goodluck if you find one.

Jul 18, 2013 | 1996 Hyundai Sonata

3 Answers

My windshield washer motor in my 2003 Hyundai Sonata does not make any noise nor dispense any windshield washer fluid when I turn it on, but the wipers do engage


Is your wiper fluid level good?Look for leaks at pump,it's connected to container,also check your hoses leaving pump to windshield,could be loose or binding.

Dec 11, 2012 | Hyundai Motor 2003 Sonata

2 Answers

Washer fluid not working...installed new pump...no washer fluid again!! what should i do next??


Are you getting power to the pump if not check your fuse if you are check the hose to the windsheild if cut or clogged

Sep 01, 2010 | 2005 Hyundai Sonata

2 Answers

Washer motor runs but no water on windshiel


Pump could be blocked with gunge, remove it and clean out.

Apr 25, 2010 | Hyundai Motor 2002 Sonata

1 Answer

Mercury villager 1994 washer pump not working


the pump motor likely is bad. get a used washer fluid reservoir at a pick n pull yourself or at car-part.com. page with * is lowest cost.

Pump and Reservoir, Windshield Washer Removal
  1. Disconnect the battery ground cable (14301).
  2. Raise and support the vehicle.
  3. Remove the RH wheel (1007).
  4. Remove the RH front fender splash shield (16103). Refer to Section 01-02 for the removal procedure.
  5. Remove the windshield washer reservoir top bolt.

  6. Disconnect the windshield washer reservoir fluid level sensor electrical connector.
  7. Disconnect the rear window washer pump electrical connector from the rear window washer pump.
  8. Disconnect the windshield washer pump electrical connector from the windshield washer pump (17664).
  9. Place a suitable drain pan under the windshield washer reservoir (17618) and drain the washer fluid.
  10. NOTE: The rear window washer hose end is color-coded, matching the connector on the rear window washer pump. Match the colors to ensure proper installation.

    Disconnect the washer hoses from the windshield washer pump and the rear window washer pump on the windshield washer reservoir.

  11. Loosen the two windshield washer reservoir side bolts.
  12. Remove the windshield washer reservoir by sliding it out of the side slots.
  13. Remove the windshield washer pump.

    Installation
To install, reverse the removal procedure. Tighten the lug nuts (1012) to 98-118 Nm (72-87 lb-ft).

Sep 09, 2009 | 1994 Mercury Villager

3 Answers

Washer Fluid Does not work


check for leaks in the hoses other wise you need a new washer motor

Aug 26, 2009 | 2000 Hyundai Sonata

1 Answer

Location of clutch reservoir


The clutch and brake master cylinder share a reservoir. Look below the base of the windshield - the "wall" there is the firewall. You should see a large round piece about 10" in diameter with a metal fixture coming forward off of it. On top of that is a reservoir - that is the clutch and brake reservoir.

Oct 15, 2008 | 1999 Volkswagen Jetta

Not finding what you are looking for?
1998 Toyota Tercel Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...