Question about 1986 Ford Bronco

1 Answer

I can only start my truck with silinoid

Its an 86 ford bronco 2 2.9lt 4x4 automatic i can get it to run but it will only stay running aslong as you have the two terminals on the silinoid connected you disconnect it i lose all power again. cant turn it on with the ignition.

Posted by on

  • l0vesk1ller Jan 16, 2009

    how do i get the old one off its rivited on ?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 333 Answers

Try changing the solenoid and looking for a broken wire from yhe solenoid to the starter. if this does not work the most common problem is that the ignition switch is bad.

Posted on Jan 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

We can get the 86 bronco II to start and run but will not go when put into drive or reverse?


Check your Transmission Fluid. If it is low fill to the recommended level. If it smells burnt it is time for a Rebuild.

May 14, 2014 | 1986 Ford Bronco II

1 Answer

Will crank but wont stay running where is the fuel filters located


my 86 bronco II the fuel filter is under the car right under the drivers area mine is also an E.B 4wh 6cyl 2.9L if that matters

Oct 11, 2010 | 1986 Ford Bronco II

1 Answer

1989 Ford Bronco. When I hooked up my battery I can hear the high pressure fuel pump running even though the key is turned off. I can start the truck up and it will run for a while. I took it for a spin...


if the key is off and the fuel pump still running then the fuel shut off switch and or the fuel pump is bad and needs replaced. More than likely the fuel pump might need to be replaced. (my 86 5.0 did the samething)

Aug 12, 2010 | 1989 Ford Bronco

1 Answer

I have an 1988 ford bronco 2 automatic V6 i pulled


There are shift solenoids in the transmission and apparently there's a problem them. I would get it to a trany shop and have it checked right away. If you continue to drive it you will ruin the transmission. Are sure you put the right computer in the vehicle? If you put a computer from a Bronco II with a manual trans in a vehicle with an automatic trans, the trans won't work right.

Jan 22, 2010 | 1988 Ford Bronco

1 Answer

Bronco tranny wont shift out of first


sounds like you burnt it up. how long did u drive it like that?

Nov 04, 2008 | 1989 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...