Question about 2002 Buick Park Avenue

1 Answer

Key wont come out ignition

Once I turn the car off the car and try to take the key out it wont come out. It will not go back to the start of the ignition process.

Posted by on

  • arnoldr922 Jan 16, 2009

    is that the only solution?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 286 Answers

Hi Arnold
Sounds like you require a new steering lock.
Not a lot you can do with faulty ones I am afraid.

Good Luck !
John.

Posted on Jan 16, 2009

  • John Quinn
    John Quinn Jan 16, 2009

    Hi Arnold.



    You can try a little squirt of oil, it´s not recommended in steering locks, but its worth a try if it frees it of !



    Good Luck.



    John.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Having problems with car bstarting due to something with ignition why


I am not sure if the problem is because the steering wheel is
locked up....if it is turn wheel back and forth while turning key
in ignition. If that is not the problem tap the key while it is in
the ignition and try turning the key....keep your fingers out of
the way....you may have to do this more than once. A small
shot of lubricant never hurts. Good luck.

Regards,
Dennis

Sep 07, 2014 | Cars & Trucks

1 Answer

Ignition switch start


did you try moving the steering whell back and forth while trying to turn the key...

Nov 15, 2013 | 2002 Chevrolet Monte Carlo

1 Answer

I have a 2002 sunfire... and i have trouble turning it on. Once it startes it is stuck there because it will not turn at all. Once it is in this position the wipes wont work, the windows wont roll down,...


sounds like you need a new ignition, reason nothing works cause once it doese turn over n starts the car the tumbler is stick in the starting position jus not far enough to keep the starter engaged but far enough the it still trying to go trough the start process which cuts the power to everything else till the ignition returns to the on postion

did you try jus turning the ignition far enough to when the starter engages jus let go of it so the car doesnt start and see if everything else still doesnt work if it dont i belive its the igniton

also with out starting it or engaging the starter as in just turning the key on to get power does anything work?

Jul 12, 2012 | 2002 Pontiac Sunfire

1 Answer

1992 toyota celica key wont turn and alarm system going off


The steering lock may be binding the ignition lock cyl preventing the key from turning or the key may be worn out. Try turning the steering wheel back and forth while wiggling and turning the ignition key. To get the alarm to turn off without starting the car try locking and unlocking the vehicle from the passenger side door. There is a micro switch on the drivers side door lock cyl that may be bad and preventing the alarm from dis arming. This is all providing it is a toyota factory alarm sys.

Jun 06, 2012 | 1992 Toyota Celica

1 Answer

Engine cuts off while driving


Sounds like a bad MAIN relay, that controls fuel, It may also be a bad distributor, contact for more help. Thanks for using FIX Ya

Apr 03, 2010 | 1993 Honda Accord

1 Answer

1999 Pontiac Sunfire ignition lock cylinder changed but car has anti theft and car wont start. How can I get it to start?


try turning the ignition on try to start then without shutting key off wait 10 mins then shut key off then back on but do not try starting leave on for ten mins then back off turn key back on to run but do not try starting it wait ten mins then if it reset it should crank over and start if not repeat all steps again

Sep 19, 2009 | 1999 Pontiac Sunfire

1 Answer

KEY WONT TURN IGNITION


Your car uses a transonder key, a key with a small chip embedded inside. The transponder is matched to the immobilizer unit in your car. When the key is inserted into the ignition, the immobilizer searches for that transponder, if it's not near the ignition, the car will just keep turning over and not start. Your only real options are to replace the steering lock or buy a transponder bypass unit, which I do not recommend. Just do a google search.

Aug 09, 2009 | 2003 Honda Pilot

1 Answer

My Car will not start, the key wont turn at all


THe tumblers in the ignition cylinder are probably worn therefore won't alow you to turn the key. Try inserting the key and jiggle it around while you are trying to start it. Sometimes it will work.

Dec 24, 2008 | 1995 Mitsubishi Eclipse

1 Answer

When turning on car turn key all the way nothing happens, then I turn back the key jiggle it then turn it on again it starts up. Told it was the ignition switch, trying to find info. on how to replace this...


On the back of the ignition switch is a plastic casing which retains a spring to return your key to the correct position once the car has started. The plastci casing wears and the spring does not work sufficiently. You need to replace the ignition switch casing/back end.

Jul 26, 2008 | 1999 Volkswagen Passat

Not finding what you are looking for?
2002 Buick Park Avenue Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...