Question about 2003 Jaguar S-Type

Open Question

Jaguar Navigation system doen't always talk and disc is stuck

The navigation disc will not eject from the navigation system for checking. Currently running version 12 - 'Where is maps'. The jaguar is 2003 model S-type.

The voice over directions do not always come on, sometimes for quite a while despite pressing the voice button (the amount of voice over can vary greatly from long periods with no voice to sections with good verbal support). Also when the system re-routes, the directions will sometimes take a bizzare turn in the opposite direction for a couple of kilometres and then double back.

Posted by on

  • haru2009 Jan 28, 2009

    My system is not talking at all on my 2006 S-Type.

×

5 Suggested Answers

  • 21 Answers

SOURCE: Is it difficult to replace spark plugs in a Jaguar XJ8

Your car does not have plug leads so that will save you a job,the spark plugs are fairly easy to do tho.
Open the bonnet,either side of the engine at the top there are 2 black covers bolted to the top of your engine,bolted to those are 2 smaller covers,remove the 2 smaller covers which will reveal your ignition coils,remove the ciols and your spark plugs are there.
You will have to remove the air filter assembly tho on the right hand side which is easy enough,remove the bolts from pipe at the rear middle of engine,undo the clips which houses the filter and disconnect the engine breather pipe.Re assemble in reverse order,
N.B the spark plugs dont want tightening too tight..or too loose,when the plug nips up just give it a little nip again..GOOD LUCK

Posted on Dec 14, 2008

latoss101
  • 47 Answers

SOURCE: x type jaguar boot will not open

it sounds like you need to wd40 the locking system .
it sound like its stiff this sould sort it out .

Posted on Jan 03, 2009

crayzeetrayn
  • 837 Answers

SOURCE: I need serpentine belt routing for 1999 Jaguar XK8

This is a view of the correct belt routing ..

bb09405.jpg

Posted on Mar 24, 2009

  • 52 Answers

SOURCE: 2003 Jaguar S-Type, programming a key fob

If its a new key fob the only way you can program it is this the factory scan tool, u'll have to take it to a dealership for them to do this and they will charge you .5 hrs for labor.only x-types can be programmed without the jaguar software. Im guessing it will cost you between 40 and 50 bucks to have them program it.

Posted on May 11, 2009

raygin
  • 322 Answers

SOURCE: how do i fix code po420 & po430 on 2003 jaguar

Both these codes relate to Catalyst efficiency below threshold on banks 1+2. This is normally caused by a combustion fault. This fault may be shown due to a faulty sensor in either air imput or exhaust systems, Get the memory read at a dealers or good garage. If you had a serious problem the car would not drive well.
Hope this helps - good luck.

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stuck CD in JBL 4 disc CD Changer / Navigation


before you press the cd on button keep holding the eject button while you press power on, I know this works for computers etc.

Feb 13, 2016 | 2013 Toyota Highlander

1 Answer

I have an 06 jeep commander with navigation when we bought it the navigation worked wel we hit the eject button for the navigation not realizing it and no disc ejected and now it says to insert disc but no...


Hi Amanda, boy did this post take a wrong turn! All I can suggest is to pull the fuse or disconnect the battery and maybe it will reset, make sure you know your theft code before resetting. This procedure might be in your manual, you could also search you tube for a solution

Mar 19, 2015 | 2006 Jeep Commander

1 Answer

Navigation CD is stuck in the unit, how can I remove the cd?


Hi Eric. I would recommend repeatedly pressing the navigation eject button about 5 times to see if the unit will respond. If not, there is a fuse in the right rear area above the battery. On the trim cover that folds down to access the battery is a fuse label. Pull the fuse for the Navigation system and leave out for 10 minutes to let the unit cool. Reinstall the fuse and try once again to eject the disc.

Dec 24, 2013 | 2002 BMW 7 Series

1 Answer

Eject a disk in volvo xc90 navigation unit


the whole unit will have to be removed and disassembled.

Mar 06, 2013 | Cars & Trucks

1 Answer

Navigation dvd will not eject in Infiniti G35


This is a free forum we charge nothing so not sure what you are talking about as far as payment goes?????>

Jun 05, 2012 | Infiniti G35 Cars & Trucks

1 Answer

2005 Mercury Mountaineer with DVD Entertainment System that will not read disk


The data on the DVD map disc ages at a rate of 15-20% per year. As the data ages, the functionality of the navigation system declines. Offering GM customers new navigation DVDs will ensure that the customers have the latest information for their system.

General Motors offered a Navigation Disc Update Program for alot model year vehicles. This program concluded on December 31, 2009. The DVD Navigation Update Program policy has changed and customers are no longer eligible for free annual updates, however, a navigation DVD update disc can be purchased for $199 (USD) + shipping.

If the navigation disc is needed for a warranty situation, the disc can be purchased for $120 (USD). The dealer must provide a VIN and RO# XXXXX qualify for the reduced price. The dealer must call the GM Navigation Disc Center, as this option is not available on the website.

The GM Navigation Disc Center launched on March 15, 2006. There are two ways to obtain an updated disc:
* Via the web through gmnavdisc.com
* GM Navigation Disc Center 1-877-628-3472

Technical Service Bulletins are sometimes generated to address specific navigation radio operational or performance issues. When a navigation radio bulletin is issued, it may contain instructions to utilize an advanced vehicle navigation (AVN) software update with a specific part number. GM dealers must order advanced vehicle navigation (AVN) software update discs as directed in the specific bulletin.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 13, 2012 | Cars & Trucks

2 Answers

Navagation just stopped working 06 oddssey after 6months


Unless it has been stolen, it is unlikely the disc is missing.

This disc the error references comes installed inside the navigation unit that is underneath the driver's seat.  There is absolutely no reason to pull the disc out, unless you are replacing it with a newer disc.
  It is possible to accidentally hit the unit with your shoes or while vacuuming the floor in that area.  Check under the driver's seat and make sure that the unit's door is not open.  If you still have a problem, then open the unit's door all the way, press the eject button and check the disc for scratches. If no disc comes out, then you are definitely going to need a replacement. If a disc comes out, check it for scratches and reinsert it if it looks ok (as it should).  Then close the unit's door and retry to use the navigation system.

Apr 14, 2009 | 2006 Honda Odyssey

1 Answer

07 h3 navigation


It is actually located behind the navigation screen.

Turn off the radio.
Press and hold the CD eject button until the display unlocks (about 10 to 15 seconds).
Let screen move outward and rotate downward.
Press the DVD eject button just exposed behind the display.
Remove DVD, insert new one.
Rotate display upwards and press gently on all four corners to slide and lock display back into original position.
Turn on radio, navigation DVD should start update process, let it finish.

Jan 29, 2009 | 2007 Hummer H3X

1 Answer

2005 honda pilot with navigation, i purchased this unit from the usa and imported it to canada. navigation system doesn't work, where is the navigation disk slot located and is there a disk for north...


same problem, disc is located under passenger seat, talked to honda canada , alpine and honda usa, they dont make a disc for 05, couldnt get nav in 05 cannadian pilots , they dont even make north america disc just stricly usa maps

Jan 19, 2009 | 2005 Honda Pilot

1 Answer

Nav system


Installing the DVD Map Disc Your dealer/retailer may have installed the map DVD. If the map DVD was not installed, do the following to load it:
Read the following steps completely.
  1. Turn the ignition on. The vehicle must be in P (Park) to perform this operation.
  2. Press (power) to turn the navigation system on.
  3. Press the NAV hard key.
  4. Touch the Insert Map Disc screen button. The screen opens to access the map DVD slot.
  5. Load the map DVD partway into the slot. The system pulls it in. The screen cannot be closed until a double beep is heard.
    Notice: Pressing directly on the navigation screen may cause damage. Repairs would not be covered by the vehicle's warranty. Do not press directly on the navigation screen.
  6. To close the screen, slightly push up on the two outer corners until the screen is in position. Then push the screen in by pushing on the four outer corners until a click is heard.
  7. Set the search area. See "Setting the Search Area" earlier in this section.
Ejecting the DVD Map Disc The navigation portion of the system cannot be used if the DVD map disc is not loaded.
  1. Press the MENU key to enter the Menu options, then press the MENU key repeatedly until Nav is selected or touch the Nav screen button.
  2. Touch the Map Database Information screen button.
  3. Touch the Eject Map Disc screen button. The screen tilts, exposing the map DVD slot.
  4. Press the eject button, located next to the DVD map disc slot, and the disc ejects. Pull the disc out. The screen cannot be closed until a double beep is heard.
    Notice: Pressing directly on the navigation screen may cause damage. Repairs would not be covered by the vehicle's warranty. Do not press directly on the navigation screen.
  5. To close the screen, slightly push up on the two outer corners until the screen is in position. Then push the screen in by pushing on the four outer corners until a click is heard.

Oct 07, 2008 | 2007 GMC Acadia SLE

Not finding what you are looking for?
2003 Jaguar S-Type Logo

Related Topics:

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

66126 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...