You need to find the wiper fluid drive motor... That is what goes to the spray ports on the hood that you are showing. The resovoir sends to the motor which pulls from the reservoir and sprays out of the hood outlets. If you find it, you semply route the hoses out of the way to the hose you see on the bottom of the hood. There is no rule or mystery. Just dress up the hoses so that it looks somewhat organized..
Remember.. reservoir - motor - hood ourlets. dress up you hoses and you are good to go. Most te time the hose is close to the hood hinges, but away to not get snipped by teh hinge..
The pipe should run from the washer jets along the back edge of the bonnet then through via the hinge inot the engine compartment.
SOURCE: windshield washer reservoir tank is leaking how do I replace?
You must remove from it's mount and empty out any fluids that is in tank.fill the tank with water and locate where the leak is coming from. wash tank a few times and the let dry upside down. Get some sand paper (80 grit course) and sand area where leak is, clean area with a vacume or clean rag.you can buy a 2 stage epoxy that comes in an injection form and squeeze it out on a pc of paper and then get a q-tip and mix the 2 components together, fill the crack or hole generously with the q-tip, if you have to,let dry for 24 hours and mix more and put more on. let dry another 24 hours, replace tank back in it's place and you've solved your leak. (epoxy does wonders if its used properly.
Frankthetank
SOURCE: Windshield washer fluid will not pump
the windshield washer pump might be bad. It should be located somewhere on the reservoir
SOURCE: Windshield washers not working
I wouldn't worry about tracing the hose just yet, most likely it's a bad pump. Find the wire(s) going to the pump, usually on the bottom of the reservoir and connect a test light to a good ground. Then have someone try to 'squirt' the washer fluid while you touch the test light 'probe' to the pump's wire connector. If it lights but no fluid squirts, it's bad. They are cheap and usually very easy to replace. If it doesn't light there's a brake in the circuit somewhere. (bad fuse, bad connector, etc.) Good luck.
SOURCE: windshield washer fluid reservoir - MB ML 350
right where the lines connect to reservoir, has little black seals that leak. I recommend removing reservoir, empty it out, then use RTV silicone and place it between seals and reservoir. Let it dry for FULL day. than reinstall.
SOURCE: Replace 2001 silverado 1500 4x4 windshield washer fluid reservoir
the only solution acording to the manual is to replace the reservoir... not much to say about that, u do have the option to patch it...be careful with the product u use to glue that patch.
take care
133 views
Usually answered in minutes!
×