Question about 1988 Pontiac LeMans

1 Answer

1988 PONTIC LAmans i turn kev on and it blows the fuel pump fuse, already changed pump, still blowing fuse.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 404 Answers

Hi!
How's the fuel lines/system? looks like you may have a blocked line or fuel filter as the pump needs to continue running and if no circulation back to tank safety procedures kick in i.e. fuse blow.
Hope this helps?
Paul 'W'
Onyer~EDson(:0) {#><U.K.

Posted on Jan 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My pcm fuse blows every time i turn on the switch but if a remove my fuel pump relay switch the pcm fuse does not blow 03 alvalanche


fuel pump is bad,your relay will be also from trying to start pump.there is an outside chance your relay is bad,easier to change that first

Mar 28, 2014 | 1998 Chevrolet S-10 Pickup

2 Answers

Fuel pump fuse blows as soon as i turn key 1988 buick skylark 3 litre


OK, R U REPLACING THE SAME FUSE WITH THE OLD ONE U TOOK OUT IT NEED TO BE MATCHING THE SAME NUMBER

Jun 19, 2012 | Buick Skylark Cars & Trucks

1 Answer

My 2002 f350 diesel keeps blowing the fuel pump fuse every couple of miles. What is causing this? I changed the filter and it made it worse.


the problem could be the fuel pump fuses only blow when they are overloaded ie. if you have a 15 amp fuse & the fuel pump or whatever is drawing 20 amps the fuse will blow,if you are using the right amp fuse the fuel pump is drawing too much power & may be faulty or there is a problem with the wiring, a loose connection or the like.....hope this helps....cheers

Aug 14, 2010 | 1988 Ford F 350

1 Answer

20 amp MPI fusible link keeps blowing. turns over but acts like getting no gas until you replace fuse stars fine then blows again.


hi it is must likely youer fuel pump
after replaceing fuse lising for loud nose from
pump if so replase pump

Dec 03, 2009 | 1988 Mitsubishi Pickup

1 Answer

1988 suburban emc fuse blows . unpluged emc and still blows fuse


This model has the E C M and the fuel pump on the same fuse,it is a good chance,the fuel pump is bad.

Nov 28, 2009 | 1988 Chevrolet Suburban

2 Answers

I have had the fuse to the fuel pump blow so i replaced the pump and it still does it . so i unpluged the pump and the fuse still blowes


The problem is not the pump but in the wiring. The sensor is connected in series type(remember in school -- series and parallel) and thus is being fed higher current and/or voltage from the battery. Its the wiring which is clamped together. Examine by tracing both leads to the battery. Its insulation must have melted and come in contact with another wire which caries higher current. The fuel pump gets activated the moment you turn the ignition key 2 notches, i.e., the dashboard lights starts glowing and thus turns on the electric circuit in which the pump(fuel) is an essential gadget. So check the wiring thouroughly including the ignition key terminals.........................sodeep

Oct 02, 2009 | 1988 Pontiac Bonneville

1 Answer

ECMB fuse keeps blowing on a 88 S15 pickup. I have replaced the fuel pump & the fuse block but my fuel pump still doesn't work


Un plug the Computer to see if the fuse doesnt blow now. You may have a short in the PCM or the harness.

Aug 31, 2009 | 1988 Chevrolet S-10

1 Answer

Upon replacing my fuel pump fuse (15amp)and


Pretty sure you need a new fuel pump, it may be shorting out inside or seizing up drawing too much current blowing your fuse. There easy to change, if you need info on R & R a fuel pump get back to me.

Mar 18, 2009 | 1988 Volkswagen Cabriolet

1 Answer

Fuel pump fuse night mare


It ended up being a bad oil pressure sending unit, it is in the power loop for the pump. When the oil pressure would come up when started that is when the fuse would blow. A friend who works for a mechanic in town found a diagnosis digram for the fuel pump and that is how we found out that the the oil pressure sending was in the wiring loop for the fuel pump

Dec 12, 2008 | 1988 Oldsmobile Delta 88

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...