Question about 2007 Mercury Mountaineer

1 Answer

97 mercury mountaneer no oil pressure about 2 lbs at guage when checked

Posted by on

  • David McCreery
    David McCreery May 11, 2010

    Is it 3.0 L ? Has it been smoking out the rear exhaust pipe? Is it making noses

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Psi checked at idle speed? is the engine making bad noises?

Posted on Jan 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low oil gage and wont start1998 mercury mountaneer


check engine oil level sound like oil level very low.if oil level okay problem could be faulty oil pump or oil pump shaft to distributor broken or timing chain has lot of slack causing oil pump not to turn fast enough build up oil pressure or engine bearings worn out.

Feb 07, 2013 | 1998 Mercury Mountaineer

1 Answer

97 lincoln mark viii oil light always on good pressure


Replace the oil pressure sending unit on the engine near the oil filter.

Sep 28, 2012 | Cars & Trucks

1 Answer

High oil pressure in a toyota 100 series 1999 model 1HZ engine


Have you recently purchased the vehicle. A rebuilt agent with, racing seals & a racing oil pump, will run around 75 - 85 lbs pressure. If it just started happening on a vehicle you have had for a while, a defective guage. Or look for a plugged oil chamber, (near impossible without dis-assembly). Bad oil sending unit (part that sends the signal to the guage.

Sep 13, 2011 | Toyota Land Cruiser Cars & Trucks

1 Answer

Just bought a used 2002 chevy s10 crew cab and drove it will trailer in tow this weekend. when I got to my desination over several mountians, the check engine/guages light came on. The oil pressure was...


Normal oil pressure at operating temperature should be around 40 lbs, 30 at an idle. Either you have a bad oil pressure sending unit or you actually have low oil pressure that indicates a serious engine problem.

Jul 19, 2011 | Chevrolet S 10 Cars & Trucks

1 Answer

The oil pressure guage is not registering. There is oil in the car and the other guages work normally


check the oild sending unit and make sure it hasent been unplugged or is going bad it is eather on the backside of the motor towards the firewall in the upper center or could be by the oil filter towards the bottom side of motor. it should have 2 or 3 wires running to it connected by a plastic looking connectionon what looks like an 11/8inch nutt or plugg, make sure its plugged in good, it should be dry of oil or water if there is oil on it its gone bad you need to replace. before you start blowing smoke all over the road along with a fair amount of oil. if that isnt whats wrong check owners manual or find one online too see where fusebox is located and witch fuse supplys power to pressure guage.. i hope this helps

Jun 06, 2011 | 2004 Mercury Mountaineer

2 Answers

Should the oil pressure gauge fluctuate with speed


The oil pressure guage will fluctuate with engine RPM. At idle it should be approximately 20 lbs./sq.in, at high revs about 50-60 lbs./sq.in. Hope this helps any concerns you may have. Good luck!

Jun 05, 2010 | 2004 Chevrolet Express

1 Answer

1989 F150 351 oil pressure guage starting dropping to 0 suddenly and engine light comes one. When I rev the engine it goes back to normal but a soon as the rpms drop the needle goes all the way to the left...


Hi:
Usually your oil light doesnt come on unless you have less than 10 lbs of oil pressure. You either have a bad oil pressure sending unit, or your engines oil pump is bad. The only way to verify your engines oil pressure is to buy a direct reading pressure guage and install it on your truck, or have a mechanic check your engine oil pressure. Eitherway, you need to do something soon, because the long term effects of running with low oil pressure will ruin your truck engine.

Jan 25, 2010 | 1989 Ford F 150

1 Answer

95 grand marquis oil pressure guage wont work


have someone put an actual guage on it to make sure there is enough press. to show on dash.

Nov 11, 2008 | 1995 Mercury Grand Marquis

Not finding what you are looking for?
2007 Mercury Mountaineer Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...