I let my car sit with the drivers window open in my garage for a week and now I went to use it and the drivers door handle that auto opens the door will not work and the drivers window switch now controls the passenger window and not the drivers window. I hear a clicking noise comming from the switch area. There is also a error message that says "Child Safety Window Fault" Please Help
An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: Drivers door and window Does not work...
You'll need to remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. Then pull back the weather seal
(can't reuse it, but it's not that important) and you will be able to
access everything.One of the wires may have come loose from the harness and then come into contact with the other wires
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
your master control module is bad..we just did this with a close friends' jeep.. it went all funky and I couldnt figure it out at first..the dealer we took it to fixed it because it was and still is under warranty.. thats what was wrong with hers..
i have 06 trailblazer chev all discribed is same here what idid ,behind drivers seat under pull seat are fuses 2 near door silver fuses I pulled them out and put back and windows and door worked only for it will happen again I will replace them and find out if it is the trouble u could try same if it helps
the handle is a small square under the dash drivers side next to door jam if u open drivers door kneel on ground look under bottom of dash bam! there it is. to set garage door fold down drivers visor and u will see three small buttons pick one don't matter, now hold down your hand held garage door opener button(close to the visor) and one of those buttons u picked until flashing light starts flashing rapidly (20) seconds. thats it done !!!if this doesn't work i will have to give u the rolling code instruction, let me know
I have a 92 that did the same. After checking fuses and the relay(located under drivers seat) I discovered that the power windows control module on drivers door was bad. Went to a salvage and bought a used for $40, pulled the door panel, unscrewed and unplugged the old one, put in the used one and everything worked fine. About a week later, the passenger side motor went out and replaced that with a used power window motor. All windows now work fine.
I have the same problem - Drivers door windows wing mirrors and drivers
door lock not working also air bag light on. The car has been to a BMW
specialist for over a week as the drivers door dead locked. The mechanic used his diagnostic
gadget which showed a problem with the drivers door. All other doors
windows locks work except drivers door. Has check the power supply to
the drivers door switch all ok. Is the problem with this internal
window control switch and how does this affect the drivers door lock?
Please Please help