Low oil pressure servcie stabiltrak traction control
SOURCE: 2008 gmc acadia low beam light bulb changing
how do you change the low beam light bulb on the 2008 gmc acadia
SOURCE: how do you change an idle control valve on a 2003 gmc envoy
The idle air control valve will be located at the top of the engine on top of the intake manifold. If you hold the new valve and then look at the manifold you should see where it goes. I'm guessing it'll have 2 screws and 1 electrical connector. The one's that I've replaced were very easy to get to and replace. Not sure on your vehicle. The screws may be phillips or torx type heads. Good luck, if this helps please rate this. Thanks.
SOURCE: low oil pressure 93 GMC P/U w/350 motor w/205,000 miles gauge
While engine is running, open the cover where you add oil to engine and see if you see a good flow of oil, if good flow, could be as easy as replacing oil sending sensor. got to realize that if poor maintenance history your engine may not be building enough pressure at iddle to move your hydraulic operated valves, only when you rev it up it will pump enough to run smooth. if running engine too long, you may cause more damage to other engine components such as crankshaft and cam shaft bearings. if you can spare a few bucks, have a good mechanic check your oil pressure with a mechanical gauge. another cheap option is to replace oil pump. last resort if you love your truck as much as we do,replace engine or rebuild it. At 205,000 this is a normal symptom, other than timing chain problems, most engines don't make it that far. hope this helps!
SOURCE: LOW OIL PRESSURE ON 2007 GMC SIERRA 1500. CHANGED
have it tested using a manual gage if still low then main baring ore most likely bad that would mean a over hall if is really low and bearings bad should be making rattle noise when started up first few seconds
Testimonial: "thanks alot.truck is not making a rattling noise.we did check it with a manual gauge.it read about 10 at idol. press. gets better as you incr speed"
SOURCE: how to reset computer after an oil change on a gmc
SWITCH IGNITION ON ENGINE OFF.REPEATEDLY PRESS VECHICLE INFORMATION BUTTON UNTIL OIL LIFE REMAINING PERCENTAGE IS DISPLAYED.PRESS AND HOLD SET/ RESET BUTTON UNTIL 100% DISPLAYED.CHIME WILL SOUND 3 TIMES AND CHANGE ENGINE OIL SOON MESSAGE WILL GO OFF.YOUR VECHICLE INFORMATION BUTTON IS THE LITTLE SQUARE BUTTON WITH A LITTLE CAR SYMBOL WITH LETTER i AND THE SET/RESET BUTTON IS THE LITTLE SQUARE BUTTON WITH THE CHECK MARK ON IT.THE BUTTONS LOCATION IS ON RADIO PANEL WHERE RADIO AND GPS IS.
1,266 views
Usually answered in minutes!
×