Question about 1989 Ford F 150

1 Answer

Losing spark on 89 f150 5.0L replace ignition module cap & rotor checked fuel pressure ok

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 70,387 Answers

Replace the pickup coil in the distributor.

Posted on Jan 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

89 s-10 4.3 MISSFIRING


You don't have a carburator. Remove the intake manifold and replace the fuel pressure regulator spyder assy.

May 20, 2010 | 1988 Chevrolet S-10

1 Answer

1991 mazda mx6 start ,runs for 15 minutes then shuts off and wont start for a hour later i changed ignition coil ,cap n rotor but no luck


This Sounds Axactly Like A INTERMITTEN IGNITION CONTROL MODULE Problem.
Check for SPARK While The NO START CONDITION is IN EFFECT and if NO SPARK
Replace IGNITION CANTROL MODULE
BUT If you DO Have SPARK then Go to the Fuel System and Start at the FUEL PUMP and EUS a PRESSURE GAGE to Check for PROPER FUEL PRESSURE, Also Fuel FILTER Could be A Candidate NOT VERY LIKELYBut Still Still May at Liest CONTRIBUTE to this Condition. But My Experience POINTS at The Ignition Control Module

May 12, 2010 | 1991 Mazda MX-6

2 Answers

1990 Isuzu 2.6 L 5 spd. No start.. Fuel pressure is ok, not getting spark. Checked coil, ignition module, distributor, computer and coil wire. No power coming from the coil. Small voltage going into...


assuming you the coil, plugs, cap, rotor and wires are good. check the cam sensor, If you have 12 volts to the coil using a 12v light tester. The cam sensor responsible for sending info to the computer telling it that the cam is turning, then the computer tell the coil to dispurse the charge/sparks to the distributor as distributor distribute the sparks to each plugs from the rotor of the distributor. Replace the cam sensor, it tend to go bad over period of time.

Dec 23, 2009 | 1990 Isuzu Spacecab

1 Answer

89 f150 to fireing


Check and see if u have spark to the plugs, if you don't replace the TFI ignition module on the distributor and the pickup inside the distributor, the dist must be removed to do this coil pickup replacement.
Comment posted on Mar 04, 2009 also check the fuel pressure if the spark is ok, the ignition is the ,most common issue. Comment posted on Mar 04, 2009 also check the fuel pressure if the spark is ok, the ignition is the ,most common issue.

Mar 04, 2009 | 1989 Ford F 150

1 Answer

Losing spark


there is a little box that i had above the engine to change in our ford f150 1987 ran just fine after or check spark plug relay

Jan 16, 2009 | 1989 Ford F 150

1 Answer

Galant Special Edition 1994 Motor does not start


this maybe caused by no fuel or faulty fuel pump, ignition coil, wire and plug crank position sensor. first check for spark by removing on spark plug wire and put a spark plug in the spark plug wire boot, donot touch the plug only the boot have someone crank the car over. if you see spark, that part of the ignition is good. if not, check the coil resistance if should 40 to 80 ohm with a volt meter pf not replace. if ok, but no spark check the igniton control madule make sure the coil and module are receiving current. if not check the fuse that feels them. if it is ok, check distributor cap and rotor. if rotor and cap are fine, check for fuel at either the fuel filter, the fuel return line or removing some spark plug and see if they are wet. if there is no fuel check the fuel pump and the fuse and relay that control the pump. if there is fuel with high pressure but there is no spark, check the crank sensor for signal with a volt meter while cranking the vehicle

Jan 02, 2009 | 1993 Mitsubishi Galant

2 Answers

94 Aerostar won't start. No fire


1 Inspect Battery Damaged or faulty battery and/or connections. here is a list of things u can check hope this helps Shaun 2 Inspect Coil - Ignition Damaged or faulty ignition coil or ignition coil circuit. grey_line.gif 3 Inspect Fuel Filter Clogged or dirty fuel filter grey_line.gif 4 Inspect Fuel Injector Pressure Regulator Faulty fuel injector pressure regulator or circuit. grey_line.gif 5 Inspect Fuel Pump Improperly functioning fuel pump or circuits. grey_line.gif 6 Inspect Wireset Damaged, worn, or deteriorating spark plug or coil wire(s). grey_line.gif 7 Inspect Control Module-Ignition Faulty ignition control module or circuit. grey_line.gif 8 Inspect Solenoid Switch Damaged or faulty solenoid switch or solenoid switch circuit. grey_line.gif 9 Inspect Starter Damaged, worn, defective, or faulty starter or starter related circuit. grey_line.gif 10 Inspect Neutral Safety Switch Damaged or faulty neutral safety swittch or circuit. grey_line.gif 11 Inspect Fuse Corroded, burned, or shorted fuse may be interupting power source. grey_line.gif 12 Inspect Fusible Link Corroded, burned, or shorted fusible link may be interupting power source. grey_line.gif 13 Inspect Battery Cable Corroded, broken or poorly connected battery cable. grey_line.gif 14 Inspect Spark Plug Wire Loom - Performance Improperly adjusted or worn/malfunctioning carburetor. grey_line.gif 15 Inspect Distributor Cap Loose or cracked distributor cap grey_line.gif 16 Inspect Distributor Cap And Rotor Kit Loose, cracked, or worn distributor cap and ignition rotor. grey_line.gif 17 Inspect Fuel System Pressure Incorrect fuel pressure being delivered to carburetor or fuel injection system. grey_line.gif 18 Inspect Fuel Injector Plugged, dirty or poorly connected fuel injector. grey_line.gif 19 Inspect Ignition Switch Worn, damaged or faulty ignition switch or circuit. grey_line.gif 20 Inspect Spark Plug Fouled, damaged or broken spark plug(s). grey_line.gif 21 Inspect Belt Incorrectly routed, adjusted(tensioned), missing or worn drive belt(s). grey_line.gif 22 Inspect Timing Belt Slipped or broken timing belt. grey_line.gif 23 Inspect Timing Set Slipped timing chain or worn timing gear(s). grey_line.gif 24 Inspect Fuel Tank Contaminated fuel from rusted or deteriorated fuel tank. grey_line.gif 25 Inspect Ignition Timing Incorrectly adjusted engine timing. grey_line.gif

Nov 23, 2008 | 1994 Ford Aerostar Extended

Not finding what you are looking for?
Cars & Trucks Logo

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...