Question about 2000 Honda Accord

2 Answers

Misfires on cyclinders

The computer board went out and was replaced and programed by the honda dealership. Then the car sputters off and on but then sometimes all the time. We have changed plugs and wires, fuel injectors, coil packs, we also had the converter checked out and it still misfires. Im thinking it could be in the wiring harness because sometime it doesnt do this until the car gets warmed up. Also when the car shut down due to the board going out it drained all of the gas out of the gas tank when we tried to restart the car.

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 610 Answers

Have your catalytic converter checked for restriction especially if you ran raw gas through it. Ask your alighty Honda dealer why they returnred a poorly ruuning ride to you with no explanation. I run an independant shop, and my customers would ask me that question, although we would not return them a poorly running car without some discussion!

Posted on Oct 01, 2011

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Crank shaft sencor cam shaft censor.02 sensor

Posted on Jan 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

When I start my 1996 Honda accord the engine seems to sputter rpm gauge revs up on its own and spits and sputters as I'm driving down the road

My sputtering & stalling 1993 Honda Accord - YouTube

? 2:12
Jun 23, 2011 - Uploaded by mdpbfly
My sputtering & stalling 1993 Honda Accord ... 1996 Acura Integra, hesitation accelerating & misfire. ... 1993 Honda Accord Start Up and Review 2.2 L 4-Cylinder ... SIR B16A Engine sputter/ power loss at higher RPM - Duration: 1:14. by ... 1994 Honda Civic Check Engine Light Code Retrieval Tutorial ...

All comments on How To Solve Honda Idle Problems ...
What should I do if once I turn on my Ac my idle drops as if it's gonna die, and .... to a complete stop the rpms start going up and the car accelerates on its own. ... Honda Accord LX, and my Honda just started sputtering in idle. check engine .... My cousin replaced my radiator on my 90 civic and since then my temp gauge is ...

Acceleration Bog/Sputter/Hesitation - Honda-Tech
Jun 11, 2010 - 1990 Honda Accord Ex F22 209000 miles, recent alternator change When I ... When I take off from a stoplight I get a little hesitation/bogging/sputteringfeeling until about 2,000 RPM then ... My 1999 Accord had a similar problem (F18B2engine). ... It only lasted a second or so before it would actually rev up.

Dec 28, 2015 | Honda Cars & Trucks

1 Answer

I have a 02 rsx type-s, my check engine light is flashing and solid at points, but always on, when i had a scanner to check the code it gave me misfire in all 4 cyclinders, i changed the spark plugs a

misfire in all 4 cyclinders hmmm...... compression tester check compression 125psi is good 100 and lower is bad (head gasket they go bad) if that is good, do fuel filter,, or charge system is bad, or bad ground or bad coil

Feb 12, 2013 | 2003 Acura RSX

1 Answer

I got a tune up today on my Yukon which they only replaced 4 wires & all the plugs. the dealership says cyclinders 1&3 where misfiring. my truck runs better but stil vibrates. what could it be?

I would replace the other 4 wires and see if it's better. If so ask why they only replaced 4. Makes no sense. They should have been able to hook up a scope and see the ignition pattern, if all was well, they should have checked compression, and injector performance.

Sep 29, 2011 | 2003 GMC Yukon

2 Answers

I got a tune up today on my Yukon which they only replaced 4 wires & all the plugs. the dealership says cyclinders 1&3 where misfiring. my truck runs better but stil vibrates. what could it be?

You should have the dealership replace all of the spark plug wires, not just 4 of them. If the vehicle still vibrates like a misfire you may need to have your timing checked/adjusted. It may also be time for a new fuel filter.

Sep 29, 2011 | Cars & Trucks

2 Answers

2000 honda odyssey, sputtering and pinging, hesitating, check engine light w/ tcs light.....???

The following is from the Honda Odyssey (1999-2004) Service Manual page 19-81:

"When the Malfunction Indicator Light (MIL or check engine light) and the Traction Control System (TCS) light are both on at the same time, you should troubleshoot the Programmed Fuel Injection (PGM-FI) system first."

"The TCS indicator will come on if one or more of the following components are faulty:
heated oxygen sensor, manifold absolute pressure sensor, crankshaft position sensor, engine coolant temp. sensor, throttle position sensor, top dead center sensor 1 or 2, intake air temp. sensor, exhaust gas recirculation, barometric pressure sensor, idle air control valve, VTEC pressure switch, knock sensor, fuel supply system, automatic transaxle, and misfire detection system of the PGM-FI system."

Most major auto parts stores have a code reader that will read out your diagnostic trouble codes or DTC's that are stored in the car's computer when the MIL comes on. They will do it for free. With these codes, you can narrow down what is wrong. This is good information to have if you are dealing with a mechanic or dealership. The terminal to hook up the code reader is under the driver's side dash about in line with your right shin.

Feb 01, 2011 | 2000 Honda Odyssey

1 Answer

1999 3.8L Ford windstar misfire

replace the EGR unit
put a can of injector cleaner in the tank
check the cat converter for blocking the exhaust system

Jun 02, 2017 | 1999 Ford Windstar

3 Answers

2004 honda accord, lights went out on the radio and somd on the dash. how do you fix it? and what could have cuased the problem

Mine went out as well, it's the Radio itself. Need to replace it or fix it. I got mine fixed at Honda dealership, Radio supplied by Honda, and I paid $99 for labor.

Sep 12, 2009 | 2004 Honda Accord

Not finding what you are looking for?
2000 Honda Accord Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides