Question about 2002 GMC Sierra

1 Answer

I have a 94 gmc 2500 and replaced the battery , the battery cable the starter and the alternator the battery is fully charged and all i get is a clicking noise with no fire

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 716 Answers

Clicking Would Be The Starter Not Working Properly It Should Spin And Then Engage. It Works Up It Speed And Then Comes Forward If Its Just Clicking It Has Hung Up On Something. Id Suggest Trying To Unjam The Starter By Either Removing It Or Tapping It With A Hammer.

Posted on Jan 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Rv won't start. starter just clicked rapidly after replacement, battery tested good. Dash lights (high beam and Turn indicators ) light when ignition switch is un start position


Poor connection either at the starter, battery, alternator, or loose engine ground strap. Fully charge the battery also.

May 10, 2015 | Cars & Trucks

1 Answer

I have a 1994 GMC Jimmy 4.3 vortec 4x4 automatic, and the transmission started to slip, then the battery died, we got it home and it wouldn't start, so we charged the battery and it ran fine for abou


You may potentially have an serious electrical drain in your car circuits. The drain is slow and continuous, draining your battery charge even if you do a start. Check the cabling and look for load on your battery with a Volt meter to check for any charge drainage. Check this as a precaution before replacing any more parts.

Feb 02, 2015 | 1994 GMC Jimmy

1 Answer

My 2000 GMC Truck is decharging when i drive it i replaced the battery and altrenator in it and it still doing it


INSPECT BATTERY ELECTROLYTE LEVEL
INSPECT BATTERY CABLES/TERMINALS
LOAD TEST BATTERY,_______VOLTS @ 150 AMPS (Min SPEC 10.2 VOLTS @ 150 AMPS.)
INSPECT BELT(s),
TEST ALTERNATOR OUTPUT (on the vehicle,NOT 'Bench Tested'),_____AMPS @ 12 VOLTS @ 2500 RPM (SPEC ______ AMPS.]
TEST FOR DRAW,______(MAX ALLOWABLE 350 Ma),

Feb 23, 2014 | 2000 GMC Sierra

1 Answer

My battery is installed and fully charged but i have no power


Did you check the fuseable links from the starter ?
Do you have battery voltage at the 10 gauge wire on the alternator ?
Is the ground cable from the battery making contact with the motor and the body ?

Aug 04, 2012 | 1997 GMC Sonoma

1 Answer

I have a 94 sonoma drove it about 20 miles today and turned it off when i went to start it . it would not do anything. the other night my lights dimed a few times but have never done it again.just trying...


First check battery voltage if not 12-12.6 charge or replace battery,then with a fully charged battery start truck take multimeter and check alternator voltage it should be 13-14.5 volts if its anything less replace alternator.HOPE THIS HELPS!!

Apr 27, 2011 | 1994 GMC Sonoma

2 Answers

94 6.5 diesel spins over slow and sometimes not at all


there is more to a starting problem than batteries and testing the starter. the large share or starting problems are the following. bad cables, bad grounds,bad batteries starter bushings in the starter bad windings and brushes . first do a load test on batteries or as in this case battery replacement . were they fully charged. just because there new they need a full charge. second check cables and ends just because they look good on the out side doesn;t mean they are good they can corrode on the inside and the result is resistance cutting amps to the starter.third is the starter some will test good out of the vehicle but put them under a load and they will bind up and drag which will slow them down I will put money on the starter drag and if you need to save money try ebay a seller call bp electric sells a great one for about 89.00 plus shipping compared to 300.00 at the auto store and they work great I have one on my 94 3500 three years now.

Jan 17, 2010 | 1994 Chevrolet C/K 2500

1 Answer

I put a new starter and batter in my 95 2500 v10 motors turn over when it wants to once and a while it will catch and start what could it be maybe the allternater


Is this the same problem that you before you replaced those parts? If not it sounds to me like you have a defective starter. If this is the same problem that you before then it could be, the neutral safety switch, the ignition switch, or the starter relay battery cables, poor ground. Check the negative cable connections at the frame, is it loose or corroded? The alternators job is to keep the battery charged, it doesn't have any affect on the starting system. The new battery should be fully charged.

Dec 24, 2009 | 1995 Dodge Ram 2500

1 Answer

1995 suburban 2500, battery problems, everything shuts down


With a test light, check for power at the starter main cable, have your helper try the starter. If the light goes out, check the connections. Plus all the ground cables, not just the one on the battery.
.
If the stays on, then replace the solenoid. Frankster016

Nov 24, 2008 | 1995 GMC Suburban

1 Answer

94 4.3 wont start


CHECK THE FUSIBLE LINK THAT COMES OFF THE STARTER POST.THEY LOOK JUST LIKE A WIRE, BUT THEY GET STRECHY WHEN THERE'RE BLOWN.IF THIS IS THE CASE YOU WILL NEED TO FIND THE CIRCUT THAT CAUSED IT TO BLOW,AND REPLACE THE LINK.

Aug 24, 2008 | 2004 GMC Safari

Not finding what you are looking for?
2002 GMC Sierra Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...