Question about 1998 Chevrolet K1500

2 Answers

No heat of blower from defosters or heating ducts 2005 surburban

2005 Chevy Surburban
Currently my blower stopped working. I checked the fuse under the hood and it's OK. When I turn on the defosters or heat, I feel slight heat but no blower action, even if I turn up the switch.

I was told it may be a bad blower or a bad resister.
Where is the resister for the blower located ? I beleive the blower is in the glove compartment.

Thanks Bill

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Please see
It may be broken solder joints on a cable behind, and feeding, the temperature knob.
I repaired my 2002 Highlander thanks to this site.

Posted on Mar 15, 2014

  • nitram2 Mar 15, 2014

    Sorry, I thought I was still on a highlander problem page. Please disregard this solution for your Chevy Surburban.


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

Its the Blower Motor. It is the Round thing right Under the Glove Box. Remove that Round cap and it is Right There.

Posted on Jan 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2006 chevy cobalt, replaced the blower motor resistor and still no heat or defoster, all the fuses are good under the hood not sure how to check the relays to see if they are bad... any...

Either the controller, where you turn on the heat. Or the blend door motor is bad. Most chevy blend door motors are Under the dash in the center, behind the console. Hard to get to, but not impossible to replace.

Jan 06, 2015 | 2006 Chevrolet Cobalt

1 Answer

No heat 95 surburban

Thermostat heat range is to low if u put a 180 in you need a 195

Mar 03, 2014 | 1995 Chevrolet Suburban

1 Answer

2005 chevy silverado heat blower unit not working. One day it was working and the next day it completely stopped.

check and test motor under dash behind the glove box test resistor [fan speed ] and fan both connections are access able

Nov 08, 2017 | 2005 Chevrolet Silverado 1500

1 Answer

2002 Chevy Surburban odometer,heat/ac controls/radio/gauges

if you have poer mirrors and locks on the door he repaired,then he may have inadvertantly pinched a wire during installation,which can cause these things to ground out,as they all are tapped into the same harness. he can remove the dor and check,but 50 bucks @ a good auto electric shop will pinpoint the area thts grounding ot. otherwise you can spend hours searching for that wire that is damaged.

Apr 30, 2010 | 2002 Chevrolet Suburban 2500

1 Answer

How do i find the relay and fuse box on a 1991 chevy surburban

look under the hood you should be able to see a long black plastic box usually located on the drivers side but can be on the passenger side open it and you will find all of your major relays.

Apr 02, 2010 | 1991 Chevrolet Suburban

1 Answer


sounds like a connection at or a bad front blower motor. it's mounted under the hood on the passenger side fire wall. it should have 1 plug going into a rubber like connector. thats your power wire and another going to ground.i think back in 2001 the power wire was purple in color.
good luck chris

Mar 15, 2009 | 2001 Chevrolet Suburban

3 Answers

PCM module, ECM module 1996 Chevy Suburban K model

Powertrain Control Module = under right side of dash, near blower motor.
Engine Control Module = same as above
Vehicle Control Module = same as above

All Suburban vehicles are equipped with only one of these choices. Good luck.

Oct 04, 2008 | 1996 Chevrolet Suburban

Not finding what you are looking for?
1998 Chevrolet K1500 Logo

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides