Question about 1996 Eagle Vision

1 Answer

Windshield washer quit working

Washer fluid resivior is full and nothing happens when I push the button

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Check fuses under dash and in enginge compartment/thenif the fuses are ok then its the pump itself that needs to be replaced/ Please rate my response thank you very much

Posted on Feb 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I push the wash button for the front windshield and nothing happens if I turn the wippers on they work this is on 2012 Acadia


GMC Acadia Forum: Front washer fluid not working. Help?

www.acadiaforum.net > ... > Problems, Recalls, TSBs, FAQs & Links

Dec 3, 2010 - 17 posts - ‎12 authors
I had my 2007 Acadia in for the heated washer fluid recall a few months ago. ... bad in the Midwest, I just noticed the front washer fluid not working. ..... the fuse finally seated properly and my windshield washer now works. Front Windshield Washer Spray
20 posts
Aug 26, 2012
Inoperative Rear Driver's Side Power Window
16 posts
Apr 21, 2012
Heated washer fluid
20 posts
Jan 29, 2012
Front Windshield Wiper Motor burning out??
20 posts
Feb 3, 2011
More results from www.acadiaforum.net

Nov 28, 2015 | Cars & Trucks

1 Answer

Rear windshield washer works but front does not....Any suggestions? Washer fluid is full, fuses are good, wipers work but no fluid or sound of pump running when lever is used to spray fluid on front...


Probably need to replace the pump. Separate pumps for front and rear. Check with a test light to see if there is power to the pump. If it has power but won't work, replace the pump. If no power, you have a wiring issue. Be sure to turn the switch on and have someone push the washer button when you are checking for power. There won't be any until you push it to "wash".

Feb 01, 2010 | 2007 Toyota 4Runner

1 Answer

Windshield Washer Fluid does not come out when activated to. W/W Fluid is full and Jeep has been in garage - so not frozen. What is next to do ?


if your wipers work it is not a fuse,
if you cannot hear the pump humming when you push the wash button you will need to replace it,they are around $20.00 at Autozone

Jan 12, 2010 | 1999 Jeep Cherokee

2 Answers

Windshield washer isn't pushing out any fluid


Had that happen to me before. Simply raise the hood and locate the plastic or rubber tube running to out put nozzle on hood. Disconnect and see if fluid shoots out. If it shoots out, simple take a needle of safety pin and clean out the nozzles located on the hood and should work. To clean the nozzle, you will have to lower the hood. If you want to you can do that before raising the hood. Oh by the way I assume you have verified that the reservoir is full.

Rolling98

Jan 02, 2010 | 1989 Plymouth Voyager

2 Answers

Windshield wiper fluid not coming out


remove the hose from the wiper arm and see if when you push the washer button that the fluid comes out the hose,if it does the sprayer nozzel is plugged if not replace the pupm

Dec 02, 2009 | 2001 Oldsmobile Alero

1 Answer

1996 Mitsubishi 3000GT windshield washer will not squirt water!?


Recommend remove nozzel and clean,also recommend remove resivior pump and clean screen,may have solvent jelling up.Very comon when using cheaper solvent.note always use an alchohol base solvent in resivior and make sure water jug is clean.

Jun 16, 2009 | 1996 Mitsubishi 3000GT

1 Answer

Fluid stopped coming out


with most vehicles not sure with a honda the pump is in the bottom of the washer fluid resivoir.remove resivior and replace pump.

Oct 22, 2008 | 2005 Honda Pilot

2 Answers

Replace Fuel Filter


Just unbolt it on top and bottom and replace (remember to use two wrenches so that you don't break the hard fuel line or the mounting bracket).
The filter is located directly beneath the windshield washer fluid resivior. You will have to remove the washer fluid resivior and possibly the brake fluid resivior as well as they both get in the way.

Disconnect the filter on a surface were it's OK to spill gas on the ground, when you take the hose of it will pour out it's contents.

Oct 11, 2008 | 1998 Mitsubishi Eclipse

1 Answer

Windshield wiper fluid does not spray and how does it turn on?


The washer pump should be in the resivoir bottle...remove the plug on the bottom of the resivior and check it for power when the washer button ie pushed... if you have power, then you should replave the washer motor...
Please rate this,
Rob...

Sep 16, 2008 | 1990 Ford F150

Not finding what you are looking for?
1996 Eagle Vision Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eagle Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Stewart Dibbs

Level 2 Expert

267 Answers

Are you an Eagle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...