Question about 1995 Volvo 940

1 Answer

95 volvo 940 jetronic error codes 113 212 232

My car runs ok for a mile and then starts to hesitate and almost stall then shoots forward and almost stalls and shoots forward etc.
I have replaced the mass air flow sensor and spark plugs and fuel filter and used injector cleaner. Each fix helps for a couple of days and then the hesitation comes back.The problem is somewhat intermitant.

Posted by on

  • Anonymous Feb 08, 2009

    I have a 1995 Volvo 960 with similiar problem, the car drives fine when engine is cold and at high rpm's but when engine warms up and I have to stop it stalls and hesitates I've replaced plugs, have a new O2 sensor, and havre cleaned the MAF. I get error code 212 and am about to replace the MAF but it is very expensive. Any help quickly would be great.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Change the the O2 senor on the catalytic convert. Its probably dead.

Posted on Sep 12, 2009

  • SweVolvo Oct 09, 2009

    Error code 1-1-3 = bad fuel Injector
    Error code 2-1-1 = No O2 sensor signal.
    Error code 2-3-2 = O2 sensor signal error

    Replace the O2 sensor. Erase the error codes by removing fuse no1 for 5 minutes. Start the car and drive it down the road for 5 minutes. then read the error cods again.



×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1993 volvo 940 hesitates on rakeoff from stop.


Start by checking the sparkplugs and the plug wires,if it misfires under a load it will cause your hesitation, start there hope this helps.

Aug 30, 2010 | 1993 Volvo 940

1 Answer

I just bought a 94 940 turbo 132 K miles.runs greatit sat for 4yrs!But aftre the oil was changed it started to smoke alotit also has alot of back presure. Also has alot of smoke coming out of oil filler...


yes,volvo,s have a problem with this,remove clean and reinstall the pcv filter or replace it,excessive crank case pressure can allso lead to blowing engine seals and gaskets.

May 14, 2010 | 1994 Volvo 940

1 Answer

Volvo 2.3 Turbo 1997 stalls when the engine is hot


Check the turbo waste-gate actuator spring for proper tension.

Feb 22, 2009 | 1995 Volvo 940

1 Answer

95 volvo 940 DL hesitates injector error codes 113, 212, 232


Check the fuse to the injector. If it is out or got wet, it could mimic these conditions. let me know what happens. I have an 85 model.

Jan 15, 2009 | 1995 Volvo 940

1 Answer

1992 GL Volvo 940 stall problem


check your crankcase position sensor i dont know the exact location but can check into it

Dec 23, 2008 | 1992 Volvo 940

2 Answers

95 volvo 940 running rough


Have you checked compression on non firing cylinders? Likely has blown head gasket between these two cylinders if located side by side.

Jun 24, 2008 | 1995 Volvo 940

1 Answer

1995 940 wagon...stalls...ideas/help...please?


Could be several things; MAF ( Mass air Flow) sensor, (Yes you should have one), could be fuel pump on the rail or the filter next to it, could be electronic idle controler, clogged injectors, ect ect, a Volvo dealer can do some simple checks of the actual components and tell you, but have someone else fix it!

Jun 21, 2008 | 1991 Volvo 940

5 Answers

940 GL Stall problem


crank sensor problem

Jun 16, 2008 | 1992 Volvo 940

Not finding what you are looking for?
1995 Volvo 940 Logo

Related Topics:

1,632 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...