Question about 1991 GMC Suburban

1 Answer

1991 GMC Suburban 1500 v8 - 350 ac Question: I need to change my heater corein truck and put a new one in. Can I get to it bu pulling the glove box door off and going in right from there Without taking dash off Pleae send me picture details of how you get at it and put new care in Thankyou Tommy

Posted by on

  • tcsquirel Jan 15, 2009

    Thankyou Yes it was very helpful Thanks Pal

    God Bless You



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,118 Answers

I know one thing you do not have to take dash board out and yes you do take glove box out. you might have to take one bolt out under dash on far right but thats all. there is one screw top far right on heater box upper thats a bear other than that it is not that bad. if you need a diagram most major autoparts stores have web sights you can go to for detailed assembly and disassembly instructions and diagrams.

Posted on Jan 15, 2009

  • ccn7 Jan 15, 2009

    you bet. good luck. OLD SCHOOL.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I change the heater resistor?

Remove the glove box, you will see two connectors held in with screws with wires going to them. The lower connector is the resistor pack. Disconnect the connector, remove the screws and the resistor pack will slide out when pulled on. Then put the new resistor pack in making sure the orientation is correct, install the screws, reconnect the connector and install the glove box. Then you should be all set to go. I hope this info helps!

Aug 26, 2014 | 1991 Subaru Legacy

1 Answer

1991 gmc sierra 1500 p/u-can not locate blower motor speed control resistor. I've looked under dash, pulled out glove compartment, looked on firewall, I give up.

If its not near the blower motor, it may be on the hvac box on the firewall in the engine compartment. It depends on if it has ac or not.
They are usually behind the glove box mounted in the side of the heater box.

Sep 26, 2013 | 1991 GMC Sierra

1 Answer

How to fix the front heater blower motor in a1995 gmc k1500 suburban, it makes a screaching noise.?

if the motor hasnt been running for a long time it will squeel. my father has a k1500 truck the same year and to change the motor you need to remove the glove box

Feb 12, 2011 | 2002 GMC Sierra C/K1500

2 Answers

Where is heater blower motor located on 1500 Suburban

The heater motor is inside under the glove box.If it stops working sometimes you can kick it with your foot and it will work untill you shut it off. Hope this helps ya.

Feb 22, 2010 | 2003 Chevrolet Suburban 1500

1 Answer

How to get access to a heater core for a 1985 GMC suburban K2500 350CID

This was the procces on an 86 chev 1/2 ton. Should be the same. Remove glove box. Undo manual controls for duct work. you'll see them there behind where the glove box was on top of the heater core housing. Bemove screws/bolts. Don't remember how many there are. Undo hose clamps in the engine compartment. Remove heater core.

Oct 09, 2009 | 1985 GMC Suburban

1 Answer

Ac problem

need to replace blower motor

Sep 28, 2009 | 1995 GMC Suburban

1 Answer

How do I change out a heater core on a 1997 GMC 1500 Pickup truck

you need to remove the glove box disconect the heater hoses look behind the glove box some heater boxes are two pieces and you can remove the heater half some you need to remove the whole piece if that is the case let a garage do it because they need to disconect the a/c so it needs to be evacuated and recharged if it is a two piece box just remove the bolts that hold the heater core under the dash and pull the box strait back good luck

Dec 22, 2008 | 1994 Chevrolet C1500

1 Answer

1991 chevy Suburban 1500 Scottsdale gear ratio

look in glove box or on tag on rearend on cover if both are gone divide number or ring gear teeth into number of pinion gear teeeth

Dec 15, 2008 | 2002 Ford E350

Not finding what you are looking for?
1991 GMC Suburban Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides