- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
small paraffin stove under the engine will help start it,but i have no idea where the heater is on the block ,i would imagine its fitted into a core plug hole about half way up the block but what side ??
Ok, the truck - org/grn goes to one of the sensor heater wires (wht). The truck - blk goes to the other sensor heater (wht). The truck - blk/blu goes to the sensor ground (grey) The truck - yllw/wht goes to the sensor signal wire (blk)
If you are useing one that goes where a frost plug is i usually put it in the center on the right side of the engine.(right side of engine is while you are sitting in truck). The left side has the starter in the way.
the resister block for the fan went. look under the dash on the duct work near the fan for an electrical fitting that goes into the duct work... should be two or three screws holding it in... remove the part and replace it...... perhaps unhook the battery first.