- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It's at the end of the lower radiator hose where it meets the engine. The original on some engines were staked in place and you might have to grind metal off the housing. It is in the opposite place of old time cars
They are on top of the motor, 3 on each side, just follow the wires from the coils. To access, you need to remove the two torx screws fastening each of the spark plug wire boot, and pull it out, the boot is about six inches long. You'll also need a 5/8" spark plug socket with a long extension and ratchet.
Your thermostat is located under the housing where the upper radiator hose connects to the engine. The housing is held to the engine with bolts,and has a gasket that must be replaced when you replace the thermostat. Make sure all surfaces are cleaned before reassembly.
YOU MUST REMOVE UPPER RAD SUPPORT TO REMOVE COOLING FANS..REMOVE ALL 10MM,13MM HEADED BOLTS..REMOVE 4 HEADLAMP SCREWS..7MM HEAD..THERE ARE 2 PLASTIC RIVETS THAT MUST BE CUT OFF AS WELL..HOOD LATCH CAN STAY WITH SUPPORT,LAY BACK ON TOP OF ENGINE OR REMOVE IT..MARK LOCATION ON SUPPORT..REMOVE 4 BOLTS FROM FAN ASSEMBLY,UNPLUG IT..IT ALSO COMES OUT EASIER WITH UPPER RAD HOSE DISCONNECTED..1 CLIP ON TOP OF FAN HOUSING AS WELL
There is only 4 sensors on a 2000 dodge intrepid and the bank 2 sensor 2 is the sensor located on the right (passenger) side and the one located after the catalytic converter (the one close to the firewall).