Question about 2000 Chrysler Sebring

1 Answer

Throttle position sensor

Where is it located and how hard is it to change on a 2000 chrysler sebring conv 2.5L

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 137 Answers

Its located on the opposite side of the throttle body as the throttle cable. remove the whole throttle body then remove the TPS from it.

Posted on Jan 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sensor P0340 where does it go on 2005 chrysler sebring


Trouble Code: P0340

No Camshaft Position Sensor Circuit Failure

Possible Causes:


CMP Sensor connector is damaged, open or it is shortedCMP Sensor signal circuit is open or shorted to ground or to battery voltage or 5v supply circuitCMP Sensor 5v supply circuit is open or shorted to ground or to battery voltageCMP Sensor ground circuit is openCMP Sensor is damaged or has failedCKP Sensor is damaged or has failedPCM has failed.Here's a link to your sensor.

Mar 16, 2013 | 2005 Chrysler Sebring Conv

1 Answer

Chrysler sebring code


MAP (Manifold Absolute Pressure) Sensor or MAF (Mass Air Flow) Sensor or TPS (Throttle Position) Sensor. Not that hard you just need to know where to look so I will give you a link to look up codes :-)
http://www.permoveo.ltd.uk/tabid/122/OBD-Error-Code/P0068/Diagnostics/Chrysler/Default.aspx

Jun 28, 2012 | 2002 Chrysler Sebring

2 Answers

Where is the crankshaft sensor located on a 2005 Chrysler Sebring


It is located under the starter that is for a 4 cylinder engine if you are a six cylinder or 2.7 it is located on the rear of the transmission housing above the differential housing

Aug 05, 2011 | 2005 Chrysler Sebring Conv

1 Answer

2005 crysler sebring 4 cyl no start p 0340 code changed camshaft position sensor still no start. key engaged engin turn over, fuel present, no start, occasionally get a small backfire. HELP!!!


Try substatutting the ignition module with a known goog one.Also have the camshaft CIRCUIT checked at the camshsft sensor plug in, for propper voltage.The code P0340 indicates a circuit malfunction not a sensor malfunction. Good luck.

Dec 07, 2010 | 2005 Chrysler Sebring Conv

1 Answer

Where is the camshaft position sensor located on my 2001 chrysler sebring convertible?


camshaft position sensor is at the back end of the camshaft. should be just across from the battery.

Nov 28, 2010 | 2005 Chrysler Sebring Conv

1 Answer

Where is the crankshaft position sensor located on a 2000 Sebring Conv.


removal steps (CPS) -remove air intake hose -Battery tray -Crankshaft position sensor

Apr 27, 2010 | 2000 Chrysler Sebring

1 Answer

2000 sebring conv. I am trying to replace the input speed sensor and I cannot figure out how to get to it. I know where it is (I think) but its too hard to get to. Any advice?


If you are talking about the sensor for the speedometer, the only way I know to access it is from underneath the car. Be sure to disconnect the electrical connector first with a flat blade screw driver to lift the retaining tab. Then take your box end wrench, feel for the bolt head and remove it.

Nov 19, 2009 | 2000 Chrysler Sebring

2 Answers

I have a 2000 Chrysler Sebring that wont idle. The car starts and will run only if I step on the gas pedal.


clean the IAC. Use spray carb cleaner and spray the idle air control valve. It is on the throttle body near the throttle plate. It may have become stuck with deposits.

Clean the throttle body as well. Check for vacuum leaks

Feb 05, 2009 | 2000 Chrysler Sebring

1 Answer

2000 chrysler sebring conv


this is the diagnostic procedure for your problem. (this is actually from a 3.0L engine but the procedure is exactly the same for the 2.5L)

click for full size
3f6ba68.jpg
2627050.jpg

5e54c06.jpg

Jan 20, 2009 | 2000 Chrysler Sebring

Not finding what you are looking for?
2000 Chrysler Sebring Logo

Related Topics:

349 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...