Question about 1999 Ford Crown Victoria

1 Answer

Seatbelt light on

The seatbelt light is on when the seatbelt is in and the light stays on while i'm driving

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 298 Answers

There is a tiny switch under the **** area of the seat that tells the car someone is sitting there... and a tiny switch in the seatbelt CLICK mechanism. These only have 2 wires which go down to the floor, alongside the running board and up to the dash. The switch nder your **** is NormallyOPEN and CLOSES (makes contact) when someone weighing 50lb or more sits in the seat (smart huh) It could be bent, broken, come loose from its moorings or have a wire loose... At the same time, the passenger seat also has shcu a switch and it might be STUCK or shorted. Same for the seatbelt CLICK mechanisms on both sides. If you don't like loosening seat bolts, pulling up carpeting and removing the inside panels, etc. what we call 'troubleshooting'. find someone that does - or take it to a dealer.

Posted on Jan 15, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i turn off seatbelt light 1999 vw beetle


There must be a wire connection to the seatbelt you left off? Some switch at the reel, some on the stork / catch end

Jun 24, 2015 | Cars & Trucks

1 Answer

T Belt light stays on how do I turn it off


If you meant seat belt light, are you driving with your seat belt or without? If with, inspect the wiring that goes into the bottom side of the seat belt receiver for pinched/damaged wires. If you are not using a seatbelt (not advising this, but your choice) you can get replacement buckles that will clip in just like your seatbelt does, our you could grab some off same model vehicle in a salvage yard.

Aug 20, 2014 | Cars & Trucks

2 Answers

Seatbelt light stay on for the passenger side


There is a Plug on teh Seatbelt that is under the Seat, did someone damage the Wire or Unplug the system?

Apr 07, 2013 | 2006 Cadillac STS

1 Answer

96ChryslerCirrus: 'door' warning vs odometer miles, Dome light stays on.


In the Ford Ranger, the light switch can be found in the door, right by the latch. You may need to use some WD-40 to get to work properly. -------------------------------------------------------------------------------------
zed bull

Nov 28, 2012 | 1996 Chrysler Cirrus

1 Answer

Warning light came on this morning, figure of a man with the seatbelt. What does this indicate?


This is the seatbelt indicator, its not seeing that your seatbelt is fastened ifthe light stays on and the chime keeps going off.

There is a switch inthe seatbelt that closes when the seatbelt is buckled, and if not, thelight stays on and the chime goes off.

There are a couple reasons thiscould happen. It could be a wiring issue going to the seatbelt buckle,or more likely the buckle itself. Your truck is pretty new, so if youare under 36,000 miles the repair would normally be covered underwarranty.

Also, I suggest check the Repair Manual for Jeep-WK-Grand-Cherokee-Section-08O-Restraints (page 473 and next, for Seat Belt)

Hope helps with this (remember rated this) Good luck.

Jan 21, 2010 | 2006 Jeep Grand Cherokee

1 Answer

The seatbelt light and bell stay on even if you buckle the seatbelt. is their a way to bypass or jumper out this on a 2000 ford mustang?


seems like the connection is disconnected on the buttom of the seat that goes to the seatbelt click,make sure its connected.if that is connected then change the thing that the seatbelt goes in on the seat that clicks in cause could be jamed common problem and wont let the light or noise go of .if my info was of any help to you please leave a comment ,thankyou.

Sep 02, 2009 | 2000 Ford Mustang

1 Answer

2002 VW Beetle GL seatbelt warning light stays on all the time


most likely if you look under the 2 front seats and inspect the wires that come from the belt you'll find a broken wire. just repair broken wire and you'll be back in business.

Mar 24, 2009 | 2002 Volkswagen Beetle Turbo S

1 Answer

02 VW Polo 1.2 seat belt warning light stays on .


you may have 2 problems 1 ightion switch and a seat belt pretensioner both faly common problems

Mar 23, 2009 | 2002 Volkswagen Golf

2 Answers

Jeep Cherokee 2001 Air Bag Light


I am pretty sure there is a recall on the air bag light

Feb 14, 2009 | 2001 Jeep Grand Cherokee

1 Answer

The SRS light stay on


SRS stands for supplemental restraint system. You have a problem with the airbag system. The seat belts have sensors to let air bag module know if they are buckled. Could be a bad buckle seat belt will work fine .This may be a common problem is why they said seatbelt problem

Sep 05, 2008 | 2002 Honda CR-V

Not finding what you are looking for?
1999 Ford Crown Victoria Logo

440 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...