Question about 1994 Honda Accord

1 Answer

Headlights wont turn on

Fixed drl module ,running lights work fine now,changed bulbs,fuses ok,all electrical works fine except when i switch lights on running lights shut off and have no lights

Posted by on

  • jastinkikaik Mar 18, 2009

    i have problem with my headlight will work but my hi dont and wine i move my stering weel it all gose off what do i do

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 125 Answers

Sounds like a direct short either in the switch unit or relay also could be anywhere along wire line the best way to fix this is take it to electromechanic shop or buy a repair manual ex:haynes or chiltons and have at it with multitester, light tester and alot of patience and determination, even for techs these things take time and patience, I do not recoomend this for average do it your selfer! but as I am tech and have doen this many times it can be doen by following troubleshooting section in manual.

Posted on Feb 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

If headlights don't come on on a 2000 Buick Lesabre what do you think is wong


first go for the easy stuff. do the tail lights come on? if so, then will almost guarantee it's bad bulbs in headlights. if tail lights do not come on I would check fuses first relay second. switch third.

Apr 06, 2016 | Buick Cars & Trucks

1 Answer

I need clarification on 2003 Chev Malibu DRL problems:


That piece you think is a ceramic DRL module is a resistor , When in DRL mode voltage to the low beam headlamps circuit goes through that resistor dimming the headlamps from low beam to daytime running lamps . It sounds to me like you need a new resistor ,but without doing some electrical testing it could be a lot of things . The DRL relay in the under hood fuse box could have a problem , could be the BCM - body control module , the ambient light sensor etc... Here is how daytime running lamps work .
Daytime Running Lamps (DRL)
The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the daytime running lights (DRL) or the headlights. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. With the headlight switch in the OFF position, the headlights will either be turned ON or OFF, after an approximate 30 second delay depending on whether daylight or low light conditions are sensed. The HTR A/C IGN fuse in the underhood junction block supplies ignition positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will either turn on or off the daytime running lamps, depending on whether daylight or low light conditions are sensed. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit. Ground is provided at G101. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the ON position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.

Feb 25, 2016 | Cars & Trucks

1 Answer

My 2002 chrysler sebring headlights don't work I do have park and brake lights. what would the problem be?


Your Sebring has daytime running lights (DRLs). A failure in the DRL circuits can disable the headlights. Check 40A fuse 4 in the power distribution center and 15A fuse 4, 20A fuse 10, 10A fuses 3 and 12, 20A fuse 13, and 10A fuse 2 in the junction block. If the fuses are OK, the fault may be in the DRL module or the body control module

Oct 07, 2012 | 2002 Chrysler Sebring

2 Answers

Daytime running lights not working


Assuming this is an LX, check 7.5A fuses 9 and 5 in the driver's underdash fuse/relay box. Fuse 9 applies power to the DRL indicator light in the gauge assembly which connects to the DRL control unit. Fuse 5 supplies power to the DRL control unit when the ignition is on. Also check 100A fuse 41 in the underhood fuse/relay box which supplies power to the headlight relays. Setting the headlight switch to HEAD causes the headlight relays to close and apply power through 20A fuses 45 and 43 in the underhood fuse/relay box to the low beams. Low beam power also passes through the DRL diode to close the high beam cut relay and prevent high beam use during DRL operation.

Sep 23, 2012 | 2002 Honda Accord

3 Answers

Daytime Running Lights Inoperative 2002 Toyota Camry


[Information] For a 2002 Toyota Camry, the Daytime Running Lights (DRL) operate utilizing the High Beams (inner Lamps closer to the center of the vehicle front) at a reduced power.

[The troubleshooting process:] Review the Owner's Manual and ensure the test configuration matches the following criteria:
1. According to the 2002 Toyota Camry Owner's Manual (Check your Owners Manual):
"The DRL system will make your headlights come on at a reduced brightness when:
The light switch s in the "DRL" position.
The ignition is on with the engine running.
The headlight switch is off.
The parking brake is released."


2. Set the Test Conditions according to Step 1 above.

3. Check the headlight bulbs to ensure they are not burned out. If one burns out, there is a fair chance that the other would have burned out at the same time. Replace as necessary. In this case, if the high beams operate, the DRLs should also operate.
4. Test the system, ensuring the step 1 conditions are set. (Engine running, Multi-function Switch on Turn Signals in "DRL" position, headlight switch off (repeating what the manual says -- it should be obvious that in the "DRL" position, the headlight switch should be off / do not have the switch positioned to "High Beam"), and the Parking Brake "off").
5. If DRL lights do not work, check the engine compartment Fuse and Relay Box. there is a 5 Amp DRL fuse -- replace it with the spare. Test (step 4).
6. If it does not work, swap around or replace relays -- there are three (3). Any one of them could be bad (stuck or burned out). Test (step 4).
7. Other less likely possible issues could be that the Multi-function Switch is broken or a connection / wire is broken. [Beyond the scope of this process.]


My problem was that the test configuration did not have the engine running and parking brake off - Step 1. Problem solved with much thought, repetitive tests on the vehicle and going back to the basics -- what does the Owner's Manual say and where are the applicable fuses and relays located?

Dec 30, 2011 | 2002 Toyota Camry

2 Answers

Daylight Running Lights


The Module for the DRL is most likely bad, the DRL Module is squarish in shape and Black in color and would be located in the fuse area or in the engine compartment. Just pull it straight out and purchase another one and re-install. Buying new low-beam lights will not solve the problem, because if your low-beams work when you turn on your headlights than it is not your bulbs. The DRL Module uses your low beam lights, but at a lower intensity than when it is normally on, so if your low beams work when you turn on the headlight switch than your DRL Module is bad.

Jul 17, 2010 | 2006 Suzuki Forenza

4 Answers

Daytime running lights work but go out when I turn headlights on. Ruled out headlight switch, bulbs, fuses, relay, ground, and DRL module. 98 silverado 1500 has no high beams. headlights work with parking...


If you have daytime running lights but when you turn on your regular headlight on they do not come on. Take the bottom of your steering column off (Two Small Screws) and look at the back of your turn/dimmer switch make sure that the light blue wire is connected. The wires will break off after years of raising and lowering your steering column.

Jun 03, 2009 | 2000 Chevrolet Blazer

1 Answer

Headlights do not turn on at the light switch.


manual headlamps

Visual Inspection Chart
Mechanical Electrical
  • Headlamp switch
  • Multifunction switch
  • Central junction box (CJB) fuse:
    • 7 (30A)
    • 30 (15A)
    • 46 (10A)
    • 47 (10A)
  • Circuitry
  • Headlamp bulbs
  • Daytime running lamp (DRL) relay No.1


Autolamps

Visual Inspection Chart Mechanical Electrical
  • Headlamp switch
  • Central junction box (CJB) fuses:
    • 19 (5A)
    • 56 (30A)
  • Circuitry
  • Headlamp bulb
  • Daytime running lamps (DRL) full relay No.1 (if equipped)
  • Vehicle security module
  • Photocell


If autolamp system, Vehicle security module has a headlamp rela inside of it. under left side of dash.

May 26, 2009 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Day time running light problem


The problem with the DRL issue describd in the above posts is the DRl module(it needs to be replaced). The buzzing relay and intermittent on/off of passenger side DRl are indicators that the module needs to be replaced.

Feb 14, 2009 | 2004 Honda Pilot

1 Answer

Headlights on low won't come on


try replacing both headlights. sometimes if one goes bad they both wont work

Oct 09, 2008 | 1999 Toyota Corolla

Not finding what you are looking for?
1994 Honda Accord Logo

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...