I need to change a

Are you ready I wasn't but I found out how and I did first vehicle in on a small ramp two 2x8 high because you'll have two drain your rad a bit now back on top vehicle in park disconnect battery cable , disconnect fan and horns , unbolt main support cross member between headlamps and remove, front hood lacht all have to be removed , remove upper rad hose from rad and thermastat housing so you can remove rad fans four bolts on each fan on drivers side one on top one on bottom two on side very difficult to get the one on bottom side , alternator tension pulley to release belt 14mm nut located center of the pulley has to be loosend off directly underneath the pulley is a 14mm bolt that will loosen or tighten the pulley loosen off the tension and remove the belt , undo bolts to alternator upper bracket has to be tacken off the cylinder head to give you more clearence bottom bolt and alternator have to angle out together replaceing alternator bottom bolt work the bolt partially in then place alternator in position when placing passenger side fan I found cutting a notch at the side bolt holes and setting bolts in acouple of threads then sliding the fan in place work quite well then tighten all the bolts was easier they charge three hours for this job it took me a little longer working in the rain