Question about 1996 Ford Bronco

2 Answers

Speed sensor i just need to know exactly where the speed sensor is on a 1996 bronco with c/c on the 5.8l engine? everybody says on the transmission or the transfer case!!!!!! WHERE EXACTLY?

Posted by on

  • yadayada
    yadayada May 11, 2010

    on the transmission where the speedo cable used to go, round pug with 2 wire connector..

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 3 Answers

Sammy is right. it is on the front side of the rear diff above the drive shaft. it is a two wire weather pack connector and is held in by a 13mm bolt (i think)

Posted on Mar 06, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

The speed sensor is on the rear pumpkin

Posted on Jan 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P0501 code?


P0501 - Vehicle Speed Sensor (G22): Implausible Signal Possible Causes
  • Wiring/Connectors from/to Vehicle Speed Sensor (G22) faulty
  • Wiring/Connectors from Transmission Control Module (J217) to Engine Control Module faulty
  • Vehicle Speed Sensor (G22) faulty
  • Malfunctioning Left Front wheel speed sensor (in vehicles that don't use a physical G22 sensor)
Possible Solutions
  • Check Wiring/Connectors from/to Vehicle Speed Sensor (G22)
  • Check Wiring/Connectors from Transmission Control Module (J217) to Engine Control Module
  • Check Vehicle Speed Sensor (G22)
  • Check ABS Brakes for faults and diagnose malfunctioning Left Front wheel speed sensor if applicable

Category:

Mar 10, 2016 | 1996 Audi A4

1 Answer

Location Of input an output Speed Sensor on 1996 dodge avenger


According with repair manual, output speed sensor is located on the Transmission, generally positioned over the park gear and monitors transmission output shaft rotating speed; check some details in the next image...

zjlimited_819.gif

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Oct 27, 2011 | 1996 Dodge Avenger

2 Answers

How do i install a engine speed sensor on my 1998 jeep grand cherokee loredo 4.0


Ther are more than one type of speed sensor for jeeps....I am chrysler jeep tech...there are 2 speed sensors on the trans and also speed sensors at the wheels (IF IT HAS ABS)...Normally the engine speed is done by an IAC Motor...If you are meaning idle...Can you send more information....
Also you may have a vacum leak..........You have an Input speed sensor and an output speed sensor ....Do you know exactly which it is ....Both are at transmission /If 4 wheel drive see transfer case also.I have the manual at my fingertips and will be glad to assist you with any problems............................I can help................metalpoet

Mar 03, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

I need to know how to install a speed sensor for a 1996 cadillac deville


1996 Cadillac Deville 4.6L SFI DOHC 8cyl the Sensor - Transmission Speed is located mounted on transmission.

Jan 16, 2011 | Cadillac DeVille Cars & Trucks

2 Answers

WEAR DO I FINED THE SPEED SENSORD ON A 1995 FORD BRONCO


IT WOULD BE ON TRANSFERCASE OUT PUT SHAFT END.

Jul 03, 2010 | 1995 Ford Bronco

1 Answer

1996 ford bronco 5.8 litre, auto, engine idle has


Do you have a check engine light on? First thing I would do is unplug the IAC motor when the engine is warm. If the idle speed doesn't change you have a vacuum leak or a bad IAC motor. If the idle speed goes down you might have a bad TPS or IAC

May 31, 2010 | 1996 Ford Bronco

1 Answer

I have a 1996 dodge caravan with the 3 speed transmission and i need to find out the exact location of the input and output speed sensors thanksi


A 3 SPD TRANS DOES NOT HAVE INPUT/OUTPUT SENSORS..ONLY A VEHICLE SPEED SENSOR..IT IS LOCATED ON TRANS EXTENSION HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..1 BOLT AND A WIRE CONNECTOR

Jul 18, 2009 | 1996 Dodge Caravan

1 Answer

Transmission type


any transmission that is for a straight six engine. doesn't matter what car it comes out of as long as it is hooked to the same engine it will bolt up to yours.

Mar 10, 2009 | 1990 Ford Bronco II

Not finding what you are looking for?
1996 Ford Bronco Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...