Question about 2008 Suzuki Forenza
Can you tell me how to reset the airbag light on my 2008 Forenza. It comes on after the battery goes dead...
The front crash sensor is on or near the radiator support under the hood, it is a little square box, one question why do you think it has a problem? it is a mechanical device, a steel ball bearing sitting in an inverted cone, when you crash the ball bearing breaks free of the magnet, that breaks a connection and signals the airbag monitor to fire the airbags, it takes a 5+ MPH impact to set all this in motion, there are side impact sensors as well, the physics of these are a little different, they are measured in G force of the impact, hope all this doesn't bore, one note the fuel that fires the air bag is made by the same folks that make rocket fuel for the solid fuel boosters of the space shuttle.
Posted on Oct 15, 2008
SOURCE: Air bag reset 2003 318i
if the light does not go off there is somthing wrong they might have to replace the seat belts the seat belts have triggers in them when you get in an accident the triggers go off and they need to replace
Posted on Dec 04, 2008
SOURCE: My airbag light just came on.
Airbag light came on for me shortly after buying it... apparently a bad censor but came on again shortly afterwards... Apparently the car is known to have a bad sensor somewhere for the airbags.
If the check engine light stays on it has something to do w/ your fuel line... be it anywhere from the cap all the way to the tip of your exhaust. When it FLASHES there's something MAJORLY wrong, like mine likes to misfire lately....
I believe there was a recall on the headlight wires and safteybelt sensor?
Posted on Apr 16, 2009
SOURCE: airbag light stays on
This is common on the beetle. More than likely it's diagnostic trouble code 00591 E24.
It will need to be reset with vagcom or vcds software. A few known trouble areas on the beetle that trigger this light are the seat belt buckles and the wire connectors under the seat. I've seen the connectors get loose and not make contact, and in one case the wires severed from sliding the seat. You might check this before you clear and reset.
Good luck...i hope this helps.
Posted on May 12, 2009
Tips for a great answer:
Aug 01, 2016 | 1995 Ford Taurus
on Dec 07, 2010 | Infiniti G35 Cars & Trucks
Dec 16, 2015 | 2010 Chevrolet Malibu
Mar 21, 2014 | 2003 Hyundai Santa Fe
Feb 03, 2013 | 2008 GMC Sierra 1500
Jul 07, 2012 | 2007 Suzuki Forenza Sedan
Jun 23, 2010 | 2008 Suzuki SX4
Apr 08, 2010 | 1998 Chevrolet Blazer
Aug 27, 2009 | 2004 Dodge Ram 1500
Feb 17, 2009 | 1998 Chevrolet Cavalier
1,263 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: