I have a 1994 Isuzu rodeo. My clutch goes all the way to floor and won't Go into gear. I put into first while car is off and then drive off and I can't put into second until I get to 5 rpms. What could this be?

SOURCE: my clutch goes straight to the floor, cant shift gears

The most likely cause of your problem is a hydraulic system problem. Your clutch system works off of hydraulic pressure and if there is a leak or it ran out of fluid it will cause the problem you have. The first thing to do is check the master cylinder to be sure that it is full of fluid. If it is not then you have a leak somewhere.
You could have a problem with either your master cylinder or slave cylinder.

Marvin

• 85242 Answers
• Posted on Feb 14, 2009

SOURCE: i need torque specs for 94 rodeo

flywheel 80-90 foot lbs (new bolts 90), press plate 45 foot lbs

ray calhoun

• 166 Answers
• Posted on Apr 05, 2009

SOURCE: pop & clutch stuck to floorboard

probly the clutch fork or through bearing

SOURCE: 1991 isuzu rodeo wont go into gear

I had the same problem and my fluid was fine! First try to bleed it (i went the easy way and bought a speed bleeder) if that doesn't do it i replaced my slave cylinder and it worked.

SOURCE: 1999 isuzu rodeo has a high idle in park and

Check your idle air control valve. If not that try your throttle position sensor or your throttle cable may need adjusting.