a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Thread Head bolt torque and sequence
Read the threads, but it states:
According to my manual the removal and the replacement sequence are different. Removal (looking from the cam sprockets )
headbolt 1-3-9-5-7 are on the left and 2-4-10-9-8 are on the right. Remove in that progression.
Instillation 9-5-1-3-7 are on the left and 10-6-2-4-8 are on the right tighten in that order.
Tighten to 25Nm or 18 ft/lb. and retighten the cyl hd blt 70 deg plus 70 deg plus 50 deg using the angular torque guage KM-470-B.
Hope this helps. Might help to make a sketch and label the 5 headbolts on each side.
1.1. Front cylinder bank spark plugs removal: 1.1.1. Disconnect the battery from car terminals. 1.1.2. Remove the engine plastic cover. 1.1.3. Disconnect the ignition coils electrical supply cable and all three coils connectors. 1.1.4. Remove all three ignition coils screws. 1.1.5. Remove all three ignition coils out from cylinder head. 1.1.6. Remove all three spark plugs out from cylinder head (straight forward).
1.2. Back cylinder head bank spark plugs removal: 1.2.1. Remove the inlet manifold out from cylinder head. 1.2.2. Disconnect all three ignition coils connectors. 1.2.3. Remove all three ignition coils screws. 1.2.4. Remove all three ignition coils out from cylinder head. 1.2.5. Remove all three spark plugs out from cylinder head (straight forward).
Position the cylinder head on the cylinder block. Tighten the cylinder head bolts in 2 steps following the proper torque sequence. The first step is 37 ft. lbs. (50 Nm) and the second step is 68 ft. lbs. (92 Nm).
25. Cylinder Head W/intake Manifold
· Clean up cylinder head lower surface and cylinder
body upper surface.
· Install cylinder head as softly.
· Apply engine oil to screw and seat of cylinder
· Tighten cylinder head bolts in following sequence
36 Lbs /ft
60° - 1/3 a of a turn
60° -- same