Question about 2000 Jeep Grand Cherokee

1 Answer

2000 jeep dies

My 2000 GC dies when ideling but starts right back up. nothing shows on the computer. dont know what the problem is.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

When there are no faults in the PCM,and the veh. stalls and starts right back up.A reel good try would be to replace the crank sensor(flywheel sensor)

Posted on Jan 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 jeep gc won't start. Lights, battery all Dash lights had been acting strangely before this happened. Turned the car off, Swapped AC relay with starter relay and nothing.


i guess you mean starter is dead, and all lights dead.
pointing to....
the battery is dead, did you jumper cable start it?
if that works the battery is bad, dead or only dischanged.
if that dont work make sure the battery cable lugs are cleaned.
no rust on cable ends( that green junk there that all cars get)
if the head lamps die (they work key off so...)
then the battery is dead, or rusty lugs.
if battery is dead, charge it. using a charger.

Nov 08, 2015 | Jeep Cars & Trucks

1 Answer

2005 Jeep GC starts and Dies


What gets you another chance at starting it? Do you have to wait

Feb 10, 2013 | 2005 Jeep Grand Cherokee

1 Answer

My 2001 Jeep Grand Cherokee started knocking. Multiple local mechanics determined it needed new motor. A "reman" motor was puchased ($3600) and installed. On test drive the car ran great then...


All I can say is do some research online find a REPUTABLE shop and let them drive it until it dies. Three things are needed for an engine to run: spark, fuel, compression. I doubt it is a compression problem being that it is a new engine. Something is causing either spark or fuel to drop out, a good mechanic should be able to quickly identify what is missing from the equation. Find a shop with a lab scope that can test sensors that send signals to the engine computer. It could be as simple as a fuel pump getting hot and quitting. Good Luck!

Sep 24, 2011 | 2001 Jeep Grand Cherokee

2 Answers

Sometimes vehicle (2000 jeep grand cherokee) won't start. you get nothing when you hit the key, no clicking, no nothing. you may go back later and it will start. gauges go crazy. will come on. odometer and...


typical jeep gremlins on a 17 year old car
mechanics either replace all the computers and modules
or throw lots of unnecessary parts into it with minimal results

needs a volt meter an LED test lamp and a lot of time
tracing the wiring faults
starting at the battery through to the ECU and ignition

Mar 07, 2017 | 2002 Jeep Grand Cherokee

2 Answers

1998 jeep grand starts runs at an idle for about 3 mins then goes into a rough idle almost stalling. you can hear it trying to **** alot more air through the intake, and at the end of its temper tantrum it...


I have the exact some issue with mine. Ive replace the fuel pump, fuel regulator and idle air control sensor and nothing has worked. Its not showing any codes and the problems fixes itself after about 45 seconds. Any suggestions?

Jan 14, 2010 | 1998 Jeep Grand Cherokee

1 Answer

The jeep dies while driving it, then won't start. if it sets for awhile, it will start back up and run as if nothing happened.


I had the same problems with my 95 Jeep GC Ltd. I had the crank shaft position sensor replaced (just under $300) and now it runs fine.

Oct 08, 2009 | 1995 Jeep Grand Cherokee

3 Answers

During driving and ideling the engine simply dies,


sounds like your crankshaft sensor is faulty.I would change that first.

Jul 17, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Wont idel when warmed up


seems to me there may be a problem with the transmission, because you say it runs fine in neutral and dies when you put it in gear!!!
only logical thing if everything else you mentioned has been ruled out!!!

Jun 18, 2009 | 1995 Dodge Dakota

1 Answer

2000 Jeep GC engine reving.


IDLE CONTROL MOTOR. TRY TO CLEAN IT FIRST.REPLACE.

Jan 14, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

74269 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7221 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...