Question about 2002 GMC Envoy
Jack up vehicle and support with jack stands
Take off wheel
remove brake caliper
remove caliper bracket
remove axle retaining nut cotter pin
remove axle retaining nut
remove axle from output flange
pull axle out of vehicle
hub and bearing assembly held in by 4 bolts
installation is reverse of removal. You will need to find out the torque specs for the axle retaining nut.
Posted on Jan 31, 2009
Replacing rear wheel bearing on 2003 envoy
Posted on Jan 02, 2011
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
take the wheel off,take the axle nut off,disconnect the spindle from the ball joint or joints, take the tie rod end out of the spindle and remove the spindle leaving the axle in the transmission. Now there is three bolts on the back of the spindle take theese out and beat the hub and bearing assy out. The new one wont be as hard to put in as the old one was to come out.
Posted on Dec 30, 2009
SOURCE: ABS light won't go off
Any chance you damaged or moved wheel speed sensor, or got grease or something on it? I'd check that & make sure, (compare to opposite side) it's clean & spaced same from wheel as other.
Posted on Jul 26, 2009
remove the hub and spinle ,tie rod end ,axle nut.ball joint,and seperate from strut and then have new bearing pressed in...or rent a bearing press that works with an impact wrench,but they are a little hard to work with...good luck...lee
Posted on Sep 07, 2009
Remove center hub cap. Remove large nut behind hub cap.Lift wheel assembly off ground. Remove wheel. Remove brake calipher assembly by taking out larger bolts from back of calipher. Remove brake rotor. Pull axle toward middle of vehicle, you may have to tap axle end with small hammer being careful not to damage threads on end of axle. Remove three bolts from back, bearing housing should come out to the front.
Posted on Jul 27, 2010
Tips for a great answer:
May 09, 2016 | 2007 GMC Envoy Denali
Mar 19, 2014 | 2003 GMC Envoy
Jul 25, 2012 | 2004 GMC Envoy
Jun 15, 2011 | 2003 GMC Envoy
Feb 21, 2011 | 2003 GMC Envoy
Jul 12, 2010 | 2005 GMC Envoy
Apr 07, 2010 | 2000 GMC Jimmy
May 21, 2009 | 2003 GMC Envoy Xl
Mar 20, 2009 | 2002 GMC Envoy
Mar 17, 2018 | 2002 GMC Envoy
Dec 04, 2017 | 2002 GMC Envoy
Jun 11, 2017 | 2002 GMC Envoy
3,557 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: