Question about 1990 Nissan 300ZX

1 Answer

Check eng light come on and the code is 55

I HAVE A 1990 TT 300ZX AND CHECK ENG LIGHT CAME ON AND THE CODES IS 55!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

55 is No Malfunction. Re-check the actual ECU lights for another code just to make sure. Let me know if you dont know how to do this. Hope this helps.

Posted on Jan 14, 2009

  • Mike Butler
    Mike Butler Dec 31, 2011

    Yes, code 55 is "end of message". If that is all you get, no others are stored.

  • Mike Butler
    Mike Butler Dec 31, 2011

    Please disregard for Nissan, would have sworn original posting was for a Chrysler product. ????

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

While driving my car loses all rpms until I come to a complete stop turn the car off then turn the car back on it runs fine for a couple miles then does it again. No check engine light comes on


ur car could be falling into limp mode..wat year make an model is it? also make sure ur check eng lite even works when u first turn ignition on it normally does a bulb check an they should all light up on ur instrument panel..check for the yellow check eng light.. also scan ur vehicle sometimes codes are recorded but not hard enough to illuminate the light.but they will be stored .history codes should be checked too...hope this helps .keep me informed

Jun 28, 2015 | Cars & Trucks

1 Answer

My service eng soon light comes on with high speed acceleration.stays on till I switch eng off.when I restart car light is not on anymore so cant check codes.Back on after driving a while. Any Ideas


I'd guess an intermittent connection somewhere. check every sensor connection While in there, clean spade connectors and wire ends to a bright metal. Helped with my 20 yr old car. Didn't need any sensors replaced Although codes were saying so.

May 25, 2015 | Cars & Trucks

1 Answer

How can I be sure if my PCM is bad???


I would try disconnecting battery again. Disconnect both cables and touch them together for a few seconds. This will reset all modules. Wierd that you had so many codes after just disconnecting battery. Sometimes very hard to tell if ecm is bad.

Dec 01, 2014 | 2006 Pontiac Torrent

1 Answer

What would make my 1993 dakota not get spark


do the computer self read.ignition on off on off on then the check eng. light flashes the codes.if the check eng. light doesnt come on at all then computer is not functioning, so no spark. check power fuse eng.compartment. need a manual for codes.

Jun 08, 2014 | 1993 Dodge Dakota

1 Answer

2005 dodge grand caravan 3.8 code po135 in stalled new botch o/2 sensor cleared codes drove van check eng light came back on same code whats is going on


Code 135 is for a faulty heater in the O2 sensor. Since you have replaced the sensor the problem is probably the circuit or the power source for the heater.
You'll need to check the heater circuit next.

Jul 29, 2012 | Cars & Trucks

1 Answer

300zx 1990 brakes work done rotor pads, fuel check and abs light still on sensor was replaces , what else I can do to get that abs light off ?


A component of your abs system is likely bad. It may be and usually is an abs wheel sensor that goes bad. Have the abs trouble codes read to find out exactly what is bad.

Jun 19, 2011 | 1993 Nissan 300ZX

2 Answers

1990 nissan 300z 2 2. After it runs for awhile, the rpms wants to go up about 800 to 1000 when I stop. I can push the gas pedal down and rev the engine and most times it will return to normal rpm. I...


Take to a nissan tech this sounds like a bad tps sensor throttle position sensor or a cruise control issue . Your problem is likely to serious to deal without a code reader an having the vehicle in front me. Think of safety first here or a accident.

Oct 08, 2010 | 1990 Nissan 300ZX

1 Answer

I have a 300zxb1990 tt. And the hicas light turns on


if you want to delete the hicas then just remove the pump and plug the line running into the differential. If you want to keep it then i'd suggest you replace the whole system. Is you check engine light on?

May 19, 2010 | 1990 Nissan 300ZX

Not finding what you are looking for?
1990 Nissan 300ZX Logo

Related Topics:

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...