Question about 2001 Volvo S60

1 Answer

CAR WONT MOVE BUT TURNS ON

DRIVING THE CAR AND A MESSAGE CAME ON SAYING LOW BATTERY VOLTAGE,AND THEN IT SAID BRAKE FAILURE STOP ASAP,AND IF THAT WASN'T ENOUGH IT SAID LOW COOLANT STOP DRIVING ALL WITHIN 45 SECONDS THEN ROLLED OVER TO A PARKING SPACE GOING A MILE EVERY 3 HOURS AND DIED. HELP

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 66 Answers

Need new alternator or battery cables? maybe battery.

Posted on Jan 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Cressida How do i know if my alternator is bad?


if the alternator is not charging , there will be a red battery light on the dash
reasons for engine stopping are
broken timing belt/chain, cam/crank position sensor failure
immobilizer activation
ignition control module failure
run the fault codes as some engine lights only light up for urgent problems that require you to stop the engine

Oct 08, 2016 | 1991 Toyota Cressida

2 Answers

What would cause your car to stop running while driving?


failure of the timing belt
failure of either cam/crank position sensor
immobilizer cut in
battery failure / broken battery lead
blown ING fuse
out of fuel
pump failure
overheated

Oct 11, 2015 | Ford Expedition Cars & Trucks

1 Answer

What fuse or fuses control the top, a c, and sds system on a 2004 sl 500


There should be a fuse chart located with your vehicles tool kit. In order for the top to function, the partition cover located in the trunk does need to closed. The micro switch for that is located on the right side where the slide cover guide is located. The hard top light will also blink fast when the partition cover is not in place. If the light blinks slowly then there is a fault in the system. By the concerns listed it sounds as if the vehicle may have a partially dead or low battery voltage. If that is the case then you can start the vehicle and push the suspension button to raise the vehicle. That should clear the warning on the cluster. The a/c blower motor will shut off if vehicle battery voltage is low and will remain off until the battery control module see a stable battery voltage for a certain amount of time. Once battery voltage is stable, the a/c should start working again, same goes for the hard top. The instrument clusters used to show a message saying 'consumers offline' but Mercedes got rid of that message after a couple years. If it looks like more then just a low battery issue then i recommend taking it to a service facility asap as you don't want to damage the hydraulic suspension pump by driving the vehicle around.

Aug 08, 2014 | 2005 Mercedes-Benz SL 500

1 Answer

Battery light on while driving, radio stopped& now other dash lights coming on


low voltage will cause these symptoms. get alternator checked and battery checked

Jun 13, 2013 | 1995 Lincoln Continental

1 Answer

My car will go off gear when i brake hard and it takes a few seconds to pick up gear again


It sounds to me like your transmission fluid level is low, when you brake hard the fluid moves to the front of the pan and leaves a void for the filter to grab air instead of fluid. When you stop the fluid settles back and away you go again. This could cause premature transmission failure so check it soon and top it up ASAP. With the transmission cold the fluid level should be near the add mark, full mark only if the trans is hot.

Jan 06, 2013 | 2002 Ford Explorer

1 Answer

My ford fusion will not start,it gives me a message saying brake failure,but then will start after several try's any ideas?


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Feb 13, 2012 | 2006 Ford Fusion

1 Answer

Why does a message appear saying low beam failure


The test system puts a low voltage out to the lights during initial startup and then measures the drop in ampage. If the result is not what the system expects it turns off the low beam lights to prevent damage and then displays the low beam failure message.

Did you just do an HID upgrade? THis is a very commong result after the upgrade, which is corrected by installing resistors

Mar 27, 2010 | 2005 Volvo S40

2 Answers

Volvo s80 2.9 brake failure stop safely asap , srs


Try removing the battery for half an hour or so and then reconnecting (check you have all your radio codes etc before you do this).

Jan 09, 2010 | 1999 Volvo S80

2 Answers

Brake failure stop asap lights and stc/abs/brake/airbag light what does it mean and how bad is it?


I have had the same problem with my car for 3 months now. It is the ABS module that needs to be replaces. Ignore the stop ASAP light the brakes will still function as standard brakes. You just don't have ABS brake functionality or STC when those lights are on. Your car should still drive fine. Go on line and order a rebuilt ABS module for about $200 and the problem is solved. Hope that helps.

Jul 02, 2009 | 1999 Volvo S80

3 Answers

99 Volvo s80 transmission problems


i got an volvo s80 and today i got the message on dashbord like this TRANSMISION REQUAIRED SERVICE what its that ?any one can help ?

Jun 20, 2009 | 1999 Volvo S80

Not finding what you are looking for?
2001 Volvo S60 Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...