I NEED THE PROGRAM PROCEDURE FOR A S1000 SECURITY SYSTEM
I HAVE A 1996 TOYOTA CAMRY WITH THE S1000 RECIEVER MODULE. THE MODULE DOES NOT HAVE A GREEN PROGRAM BUTTON. I'VE TRIED SHORTING PINS 2 AND 10 ON HE MIRROR CONNECTOR, OPENING AND CLOSING DOOR KEY IN KEY OUT PROCEDURES NOTHING WORKS. DEALERS HAVE YET TO RESPOND.
An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: I NEED THE PROGRAM PROCEDURE FOR A S1000 SECURITY...
You are quite welcome. Note that you will need to remove the S-1000 before you install a new system.
Ah, I see that you have recently joined our little community. How good are you at bigscreens? REAL GOOD? We have a little issue here with an "expert" that is posting what we think is bogus info in bigscreens. Would you consider checking out a few solutions?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Jan 2, 2013 - Uploaded by Jabali Black
My car problem started 3 days ago, it started with my Toyota security light blinking red, then a key like symbol on ...
So its a wagon? or I dont know what S/W is. If the license plate light works, the light failure sensor could be bad. It should be in the left rear corner area and have 4 wires. Green, Light Green, Yelow/Green and White/black. You should have power on the Green going into the box, and the Light Green out to the tail lights. If you have power on the Green, but no power on the Light Green, then the box is bad, either replace the box, or you can just connect the Green to the Light Green wire to get tail lights operating.
Larger harness: Green: front right speaker (+)
Pink: front left speaker (+)
Grey: +12V only when ignition switch is at ON or ACC
Blue with yellow stripe: +12V, always on
Blue: front right speaker (-)
Violet: front left speaker (-)
Red: rear right speaker (+)
Black: rear left speaker (+)
White: rear right speaker (-)
Yellow: rear left speaker (-)
Hi I'm litoshop if the security light stop blinking.then you deactived the alarm if your car has a factory alarm then the same light you see blinking look at it close and see if it's a switch push it in and put the key on and just turn on the dash light then turn it off the it should start blinking agian if it's not the light the look for a small red push botton and do the same as instructed above good luck. if this information has been useful please let us know thank you...